Electronics Forum | Sun Dec 13 10:41:57 EST 2015 | alexeis
Hi, We have developed various solutions for SPC in view of SMT production. I can tell you that the solution depends on the need you are trying to solve. Our solutions are: ASD (AOI/SMT Diagnistics) - Real-time collecting, detecting and popping hidde
Electronics Forum | Thu Feb 12 13:01:12 EST 2004 | patthemack
Thanks for your response. This is a DeHaart MPC-29. It has manual vision, no conveyor. When I bought it, only one camera was working. I fixed that, but while I was jacking with that, the electronic pressure regulator (spcjr) burned up without warning
Electronics Forum | Wed Dec 13 14:15:54 EST 2000 | Chris
I have a product where an IC is soldered using a stencil which puts down way too much paste. The result is massive bridging. Anyway, one of my coworkers claimed he could eliminate the bridging by baking the circuit board in an oven for 5 min at 90
Electronics Forum | Wed Dec 13 11:11:20 EST 2000 | CAL
CONFUSED???? The the "BIG-chip-in-the-middle" on my image is IC732. IC304 is the 52pin QFP to the right of the "BIG-chip-in-the-middle".If it worked when the "Thingy" was there and does not work when the "thingy" is not there good indications are you
Electronics Forum | Tue Dec 12 13:33:52 EST 2000 | justin medernach
Dross removal is dependent upon the "activity" in your solder pot and the usage of a inert or an "air" atmosphere. The more moving that agitate the solder, the more dross. Basics first and then the answers will make sense. What is dross? Oxidatio
Electronics Forum | Wed Dec 13 20:22:37 EST 2000 | Dave F
George We use a 0.030" dot. Here's a link for aperture sizes for adhesive printing from Alpha. http://www.alphametals.com/products/techarticles/soldrpstncl/guidelines.html Here's a link for aperture sizes for adhesive printing from Heraeus. http:/
Electronics Forum | Fri Aug 03 12:13:59 EDT 2001 | hinerman
T.A. board lok is fixed tooling. I have not used it, and therefore cannot comment on it. Their website describes it in detail for those interested. -The Grid-Lok system is completely pnuematic -Each pin locks individually via mechanical lock -Each
Electronics Forum | Mon Dec 13 21:11:53 EST 1999 | Curtis T.
Steve, I have done countless board profiling and oven reflow profiles. Here are the critical factors on you need to address. What is your board surface finish, if it is something like an OSP it will need a good amount of an active (aqueous) flux to
Electronics Forum | Fri May 14 12:13:55 EDT 1999 | P.L. Sorenson - Technical Consultant
| | Looking for a reasonably priced portable device to do strength test(shear/twist)on glue cured Cap/Res. Any suggestions? Thanks | | | My torque watch came from Waters Manufacturing, Inc. A div of Talley Industries. Longfellow Center, Wayla
Electronics Forum | Fri May 14 12:13:35 EDT 1999 | Heather
| Hi Guys, | | I am going to be graced with the good luck of processing microBGA's in the near future. A bit of a step forward from printing 20-mil pitch and wave soldering 0805's, wouldn't you say? | | So, any of you folks who have already experi