Electronics Forum | Tue Aug 08 06:13:44 EDT 2006 | spari77
hi, can anyone share experience on PCB open trace repair? we have some data that indicates that this repair is high risk and really very dependant on repairer skills. It may also cause reliability issue for trace repair. please advice.
Electronics Forum | Tue Aug 08 11:18:09 EDT 2006 | Chunks
Since we build produt and co not repair, we send our damaged boards to a place that specializes in board repair.
Electronics Forum | Wed Aug 09 04:20:19 EDT 2006 | Rob
If you kink the leads will you be able to insert it without flexing the board/moving any of the other components? Also these pin headers aren't always designed for this process so have you checked that it will take the elevated temperatures?
Electronics Forum | Wed Aug 09 07:40:45 EDT 2006 | tk380514
i dont even have the gerber files yet and i have just asked the customer to change the BOM, any suggestions for Paste in hole connectors...?
Electronics Forum | Wed Aug 09 08:59:52 EDT 2006 | zanolli
I agree with verifing this part is even high temp reflow compatible. The age of the original dwg release, 1986, and as there is no mention of high temp reflow compatibility, only a mat'l call out of nylon, leads me to think it is not.
Electronics Forum | Wed Aug 09 10:31:10 EDT 2006 | PR
pin and paste works. don't use gel flex at screen printer. Good luck PR
Electronics Forum | Wed Aug 09 12:18:06 EDT 2006 | PR
We had to replace the chains on our Omni as well. We used a non-approved oil which build up so much carbon the links would not move. Since using the high temp oil they recommend, no problems.
Electronics Forum | Wed Aug 09 14:17:49 EDT 2006 | chrisgriffin
I had a similar problem once. It turned out to be sprocket bearings. The sprocket was so hard to turn, the chain would stop a couple times per shift.
Electronics Forum | Wed Aug 09 16:46:49 EDT 2006 | nitro
We use the Tribol 930/100 Synthetic oil. Also, check the drive motor chain on the output end of the oven. I have seen the set screws back out of the drive gears, and it will kind of pop at times while running.
Electronics Forum | Wed Aug 09 18:24:30 EDT 2006 | SWAG
Great advice, all. Thanks much. I called on the Tribol 930 and there is now a blend called Tribol 1421 that is good for higher temps. Speedline recommends in place of 930 if you wish to do so. Might be something to consider for lead free stuff.