Electronics Forum | Mon May 12 17:59:55 EDT 2008 | rgduval
We're currently experiencing a spate of solder not wetting to pads of PCBs, and it's becoming more aggravating on a daily basis. At this point, we're running out of ideas. I've searched the Fine Archives for information, and, so far, haven't found
Electronics Forum | Wed May 14 12:35:34 EDT 2008 | rgduval
Thanks, Chunks. That's the one point of the experiment that we haven't tried yet. Though, we came to the same conclusion just yesterday. Dave, so far, the most help we've gotten was from the paste manufacturer. I've involved the board house, but
Electronics Forum | Mon May 12 18:45:57 EDT 2008 | locostpp
Hi All, We are embarking on the design of an ultra low-cost pick and place machine for use by small manufacturers & would appreciate some input. Here are some points: Low cost - in the region of $6-11k (higher cost versions faster) Two cameras (up
Electronics Forum | Tue May 13 08:47:38 EDT 2008 | locostpp
Yes, this is a good point and really only time will tell just how reliable such a machine becomes. What I'm aiming for is to simplify and reduce the number of sub-assemblies. For example we are building the camera/vision processor and lighting into
Electronics Forum | Fri May 30 12:41:39 EDT 2008 | severs
I say that there is a market... The question is this: -How big is the market? -Is it worth going after? -Are you the person who can do it? Cost is everything to some people. There will always be a certain segment of buyers who will buy a product base
Electronics Forum | Thu May 29 12:06:25 EDT 2008 | bsumfg
This thread is a pleading for all those PCB Design experts. A good design person with experience will design for manufacturing as well as to please the customer. Actually that goes hand-in-hand. If a board is designed well from a manufacturing standp
Electronics Forum | Thu Jul 17 10:09:06 EDT 2008 | dfhoadle
Were dealing with firmware issues for the stepper > motor, as well as communications problems with > the software. Vitronics is looking into it... > again, but even they seemed to be stumped. You > may want to ask your rep about it. Our machine i
Electronics Forum | Tue Jun 24 13:46:21 EDT 2008 | bschreiber
I know it is not what you want to hear, but first and foremost, you must consult your local regulating agencies and here is why: Solder paste contains heavy metals. We are all familiar with the problems associated with lead, but lead free solder pas
Electronics Forum | Mon Jun 30 12:41:03 EDT 2008 | realchunks
Hi Dave, I am not a sales person pushing my wares here, just my engineering experiences - so I hope I am not out of line here on this forum anymore. When it comes to selective or spot soldering - it all depends on your board design. Many people al
Electronics Forum | Wed Jul 02 14:06:57 EDT 2008 | amcross
Thank you, ALL, who have read this ad and shown interest. I've had a few common questions, so thought I might answer them here.. We are in Danville, IL -- 1.5 hours from Indy, 3 hours from Chicago, just 20 minutes from University of Illinois and its