Electronics Forum | Mon Apr 20 12:46:35 EDT 2015 | edwaterfall01
I know of an HSP478585 user who has UCT31 available. Contact me if you are still interested.
Electronics Forum | Thu Apr 23 10:33:47 EDT 2015 | sandaruwanhtml
Does anyone have the software of EKRA x5 old model. Manufactured in 2000. The serial Number is x500005. It runs on windows 3.11 version and hard disk currupted. Can anyone help me? send me a email sandaruwanhtml@gmail.com363
Electronics Forum | Fri Apr 24 13:50:44 EDT 2015 | duchoang
Try to check the SSR (Solid State Relay) in the back panel. You may need to replace one or some of them. Good luck.
Electronics Forum | Mon Jun 01 09:41:00 EDT 2015 | tnisbet
It could be the control board that mounts onto the backplane board of the pc, if you have any further questions you can contact george@goppm.com
Electronics Forum | Fri Apr 24 10:58:15 EDT 2015 | chris_jayconsystems_com
I have checked and rechecked all my dimensions on the capacitor which is a 402 size. The manual says that the center is incorrect. Need some help to figure out why it is throwing this part away seeing it passes a vision test. Any help would be gratef
Electronics Forum | Wed Apr 29 02:57:05 EDT 2015 | jandon
Immersion tin is very sensitive for handling, scratches, storage condition and time, thermal influence and washing. You will get problems in second reflow if you have double sided PCB with immersion tin surface finish.
Electronics Forum | Thu Apr 30 04:47:54 EDT 2015 | anirudh_thabjul
Thankyou once again dude, You are right.I will suggust my boss to use Immersion Silver. Regards Anirudh
Electronics Forum | Thu Apr 30 04:52:02 EDT 2015 | anirudh_thabjul
Thankyou once again dude. I finally decided to use immersion Silver because my boss is not convinced with ENIG Cost because my company is just a startup company. thanks once again for your suggustion. regards Anirudh
Electronics Forum | Fri May 01 14:46:52 EDT 2015 | aprosser
Good afternoon, We are running some aluminum boards through a 7 zone reflow oven which have 2 4 pin right angled headers on the ends that are skewing. Does anyone have any suggestions to prevent this from happening?
Electronics Forum | Mon May 04 09:47:02 EDT 2015 | erinkou
For this, I know a good pcb fab Their site is http://www.pcbway.com/e You may have a try.