Electronics Forum | Thu Feb 04 23:27:05 EST 2016 | aemery
Accupro User: Speedline, Password: Printer
Electronics Forum | Thu Feb 04 11:08:13 EST 2016 | avjelectronics
The drive on my accuflex printer crashed before I could create an initial backup. I was able restore the software install files. Now I just need the default admin password.
Electronics Forum | Mon Jun 11 11:31:53 EDT 2007 | ratsalad
According to our plant drawings: MV2VB 23' 8" X 6' 11" GSM1 8' 6" X 5' 6" A GSM2 should be the same size as a GSM 1.
Electronics Forum | Wed May 19 14:44:53 EDT 2004 | JSK
Low voltage readings on (PSU 2). should be: = is: +12V = 4.3V -12V = 8.6V +24V = 7.6V Anysuggestions? (Other than buying a new card.) Thanks, jsk
Electronics Forum | Thu Apr 25 09:27:03 EDT 2002 | fmonette
Michael, This concern is well covered in J-STD-033, section 8.6 Board Rework. "...If the component temperature exceeds 200C, the board may require a bakeout prior to rework..." In other words, you only need to worry about moisture related defects w
Electronics Forum | Tue Sep 19 11:28:09 EDT 2000 | Wolfgang Busko
Mikeal�s approach is one of the more cautious ones. IPC/JEDEC J-STD-033 clause 8.6 talks about 200�C body-temperature not to be exceeded and how it�s best measured. If you go for that method and you made sure that in your wavesoldering (that�s what
Electronics Forum | Fri Oct 09 14:01:24 EDT 1998 | Bob Barr
Charles, I am using an Air-Vac PCBRM12 to selectively solder a 96 pin thru-hole connector onto an otherwise all SMT board. Cost is $8.6K plus about $300 per flow well (nozzle.) Went from a 6 minute cycle to hand solder the connector to 15 seconds o
Electronics Forum | Tue Sep 24 15:32:22 EDT 2019 | kurtiss
During production our MPM Accuflex stopped working. When going into "Play" mode to run production it almost instantly Pauses. When going into vision setup it fails to load the PCB saying "The PCB Did Not Load". Ignoring this error and trying to read
Electronics Forum | Sat Jul 16 17:29:50 EDT 2016 | aemery
Yes, you need to run the 'offsets' calibration to correct the offset issue. If the machine is in good working order and all of the other alignments and cal's are completed then you are good shape to go to run this cal. If not, you could waste a few
Electronics Forum | Fri Nov 12 13:07:45 EST 2010 | G8reflow
Hi, The focal point of my research has been to recommend a reflow oven and develop a process for a small to low-medium production SMT soldering with the following considerations. - Lead-Free - Low to low-medium production - Forced Convection reflow