Electronics Forum | Wed May 02 16:20:01 EDT 2001 | mparker
As a second thought, just to address your problem, try contacting a local fabrication shop for restaurant supply. They are used to working with stainless steel. I once had a complete sink/workstation top fabricated to my specs. for a fraction of the
Electronics Forum | Wed Dec 20 14:26:47 EST 2000 | Charles Harper
One of my chapter authors,Dr.Rolf Funer teaches a course specifically on evaluating and qualifying new PCB suppliers.Hence,he can give the best and most complete advice here.So,just click on his name in the list of chapter authors at the top of this
Electronics Forum | Wed Aug 23 16:57:10 EDT 2000 | Dr. Ning-Cheng Lee
Regarding solder paste printing, many books available on the market all have some sections addressing this topic. Unfortunately, as of today, solder paste printing has not been the main theme of any book yet. I consider the better sources of informat
Electronics Forum | Tue Aug 22 11:17:04 EDT 2000 | Dr. Ning-Cheng Lee
The classic dilemma, cost vs. performance. In typical applications, Sn whisker growth is not an issue. It only seems to occur under extreme use (high stress, low temperature)conditions. Until this issue is fully addressed, Pd seems to be the favor
Electronics Forum | Thu May 03 18:40:34 EDT 2001 | pzohbon
We produce a board right now with a QFP that has 20 mil pitch and we are seeing problems with the solder deposition. I believe it to be a cleaning issue which we are addressing. Soon we will be pasting for bga's. Is there a problem with using inter
Electronics Forum | Wed Feb 02 17:16:44 EST 2000 | Larry
Boca, We mix them with titanium fingers, been running them for 6 months with no problems with heat. They break off rather then mangle like the titaniums, which can be a good thing! Do I like them? Sure! I found they were 1/2 the price as titaniums an
Electronics Forum | Fri Dec 03 15:38:13 EST 1999 | DaveH
Jason, Something which has not been addressed in the responses so far is the system which utilizes high volume (flow rate of chemistry over the product), versus high pressure, which indeed has the potential to damage very fine webs on fine pitch sten
Electronics Forum | Tue Jul 13 18:45:08 EDT 1999 | Dan Lambert
Jennifer, Try calling Jim Berhnard at PAA. His number is (508) 695-7557. He is the person you need to talk to. Dan | Does anyone have a US or North American phone and address contact for EKRA (Eduard Kraft)? | | I have been told by several
Electronics Forum | Tue Jun 29 17:15:02 EDT 1999 | Ryan Jennens
Does anybody have experience with this supposed drop-in replacement for lead solder. I checked out the tech sheets on this product and it seems to check out. I could not find any information about Lucent's research on it, although I was not exactly
Electronics Forum | Mon Jun 07 18:31:53 EDT 1999 | Bryan Bloom
Can anyone suggest a place on the web, or a publication that lists all PCB assembly houses? It would be great if it has a decent amount of information on each, name, address, phone, etc? I am aware of The Electronic Sourcebook already but am lookin