Electronics Forum | Thu Aug 16 14:02:08 EDT 2012 | benreben
Hi all, i search the proper method for adjusting gain/offset on fuji FCP4 can you help me? thx
Electronics Forum | Wed Jun 27 09:21:29 EDT 2007 | cyber_wolf
Does it happen on both the wide view and narrow view cameras ?
Electronics Forum | Thu Jun 28 10:21:56 EDT 2007 | cyber_wolf
Well ? Did you fix it ?
Electronics Forum | Sat Aug 18 10:06:05 EDT 2012 | cyber_wolf
There is no defined method that I am aware of. If your bulbs are old replace them. Other than that adjust the gain and offset until there is clear definition on the edges of the components. Keep an eye on the dump box.If the dump box stays relatively
Electronics Forum | Fri Jun 22 11:02:13 EDT 2007 | gregf912
I have a CP642E machine that will not function if auto adjust is enabled in Part Descriptor. Symptom: Auto pick offset causes machine to pick part off center to the point of going to end of part after several picks. This only happens to parts that ha
Electronics Forum | Wed Jun 27 08:33:27 EDT 2007 | pekantol
Have you measured the preQ rotation station(st3).Is it workin correctly?
Electronics Forum | Wed Jun 27 09:15:21 EDT 2007 | gregf912
The program that I use is the Fuji calibration program and it works fine on all other equipment that I use it on. The PDs are dialed in at 10% tolerance and the nozzles are new. I see it more on 105 and 1608 parts but it happens on 2012 and 3216 part
Electronics Forum | Wed Jun 27 09:17:43 EDT 2007 | gregf912
I have set the PQ with the CP6 station jigs. It is dialed in to 0.02mm of zero. I also checked station 5.
Electronics Forum | Fri Jun 22 16:18:38 EDT 2007 | mika
Hi, I am interested of what the Fuji field engineers has to say about this? I trust You did not do all of this "replacement & calibration" by yourself? Is this happend randomly in a previuos known good pattern program, or just with a certain parts
Electronics Forum | Tue Aug 04 01:55:29 EDT 2020 | cbeneat
How much adjustment is needed? Adjusting the snap off will get the PCB tighter/looser to the stencil. But this is only a 3 to -3 MM adjustment.