Electronics Forum | Sat Oct 18 20:35:25 EDT 2008 | arosario
I see, maybe changing my peak temp in reflow will help. I'll try do eval again... Actually, once I did have evaluated a longer pre-heat but on my previous eval, I didn't change the peak temp. Maybe reflow can help compensate to my problem in the part
Electronics Forum | Mon Jan 05 14:29:45 EST 2009 | pjc
In PA there is an annual license required, about $200 per year. There is an initial inspection and at that time they will want to see radiation survey, installation documents that state individuals have been trained on the machine. They say they try
Electronics Forum | Fri Feb 27 03:03:50 EST 2009 | exsydeco
well, you have to differentiate between "bought" and scam. If bought, means there is a transaction, you provide your service and in return you receive your payment. Scam, like this Italian, he first make payment for the first few months then and th
Electronics Forum | Fri Sep 02 11:26:50 EDT 2011 | steffenr
Overkill for sure! Program to BOM: Shouldn't have to verify the program to the BOM once it's been verified unless there is a change. Feeder to BOM" There should be some type of instruction that specifies that part goes on what feeder and where the
Electronics Forum | Mon Sep 17 09:47:18 EDT 2012 | mbnetto
Hi, Do you want to replace the SB ou just reflow it again? Do you suspect there is some "colder solder joint" in one of the SB balls ? In my opinion you are heating the board a lot... Did you put some thermocouple on the ball to check the temperat
Electronics Forum | Thu Aug 29 15:09:23 EDT 2013 | bvdb
Hi, Yes, there is a board marked "Memory Board" but it does not actually contain any memory. The memory card is attached to the CPU card. The board marked "Memory" is a board that allows you to plug in a Compact Flash (CF) memory card which we do
Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Thu Nov 13 05:35:50 EST 2014 | jlawson
Valor-Mentor has bardcode based verification solution with machine connection and control for most machines on market and options to connect to machines in various ways to lock system until verification process is done. Handles splicing and led binin
Electronics Forum | Thu Nov 13 05:36:37 EST 2014 | jlawson
Valor-Mentor has bardcode based verification solution with machine connection and control for most machines on market and options to connect to machines in various ways to lock system until verification process is done. Handles splicing and led binin
Electronics Forum | Thu Apr 23 12:22:35 EDT 2015 | ercdave1
Thank you for looking at my post. my problem is this. I have a Conceptronic Mark 111 Reflow oven that randomly turns off zone 4 and stops the conveyor belt. turning the heater and the conveyor off on the software and restarting them gets things ba