Electronics Forum: alsos (Page 366 of 1042)

Universal Lightning Head Spindles

Electronics Forum | Sun Aug 19 07:59:06 EDT 2012 | processman

Thanks for the replies guys. Interesting the one with the dryer in the air supply, will look into this. Sure some of our service guys lightly grease the O rings within the spindles, have been trying to get them away from this. Also interesting to h

Anti Magnetic Environment

Electronics Forum | Wed Aug 22 17:32:21 EDT 2012 | icin

I recently heard an interesting requirement and wanted to poll the fine members of this forum for what their interpretation would be, and if any standard would exist: "Maintain the bill of material in an anti-magnetic environment." Thanks in advanc

SiPlace Nozzle Change Issues

Electronics Forum | Fri Aug 31 11:11:27 EDT 2012 | markhoch

Those are some pretty good ideas. I like the idea of having them self-police the issue, (obviously once they have a better understanding of whats causing the problem). It also helps them correct any issues at the start of their shift that may have be

Heller Oven

Electronics Forum | Fri Sep 14 13:00:28 EDT 2012 | mark25y2001

Try to check encoder if properly locked, also check encoder connector if properley inserted, if all good, it's possible that the conveyor controller or encoder problem... to check controller related just try to set in zero value, then if conveyor are

Right flux for alpaca selective soldering

Electronics Forum | Tue Sep 25 19:26:39 EDT 2012 | caurbach

So, I just learned that alpaca isn't just a cousin of the llama, it's also a Cu/Ni alloy (imitation silver). Creeped me out at first... When you say "poor filling and no solder", are you referring to wetting problems? Do you have any photos you co

Quad QSA 30 opinion wanted

Electronics Forum | Thu Sep 27 05:47:21 EDT 2012 | bobpan

Check the software version before you buy it. If it is not version 6.75 do not buy it. This is the last version released for this machine and fixes many bugs that made running a panelized board a nightmare. 0603 parts and above is where i would stay

PCB Solder Mask Adhesion

Electronics Forum | Thu Oct 11 17:15:31 EDT 2012 | boriskilk

We have seen two issues which have caused problems with solder mask adhesion. The first was improper curing of the mask but also solder temps which were too high, particularly with a white tin finish. Rather than tell your supplier their material i

Philips/Assembleon Vibratory Feeder

Electronics Forum | Wed Oct 17 02:07:23 EDT 2012 | andras

Hi, Just for info. Hard to buy vibratory feeders on ebay: http://www.ebay.com/itm/380403397600 I bought two of them and perfectly fits to CSM66/84 (and should Topaz also ??). The guy is very slow, but finally sent me the goods. And is worth the mone

Solder Paste layer question

Electronics Forum | Sat Dec 01 13:43:51 EST 2012 | anvil1021

Do you mean the Paste Layer of the Gerber files? If so then you can check for aspect and area ratio of the component apertures (which is determined by the thickness of the stencil) there is an IPC specification for this and it is IPC-7525A I believ

Flex pcb carrier / palett

Electronics Forum | Sat Dec 01 13:51:26 EST 2012 | anvil1021

In my experience with flex the flex provider is the best place to go for these pallets. The competent flex and rigid flex providers will also provide the carriers if requested. Once you see what they are providing you, you could most probably make th


alsos searches for Companies, Equipment, Machines, Suppliers & Information