Electronics Forum | Wed Oct 16 03:14:47 EDT 2013 | alexeis
Hi Simon, I want suggest you our software tool (called TopoQC) that can help you to see AOI information by topological and find all you problems. This tool can help you to study where a problems in AOI and improve your AOI setups (programs). Please
Electronics Forum | Fri Oct 18 11:56:22 EDT 2013 | hegemon
You might try testing prior to using the Silicone if possible. Also you might try to qualify your cleaning process rather than the individual board. Clean an unrelated assembly and test it in your Ionagraph. Assuming it passes, Clean your subject a
Electronics Forum | Fri Nov 01 17:32:34 EDT 2013 | dhruv_trylene
I am sorry for not being clear enough... We have a FUJI CP642 and a IP3 machine. At present, we have to create part data for each and every part used in a job, which consumes a lot of time. I was just wondering if there was a way to minimize this?
Electronics Forum | Tue Nov 05 10:18:24 EST 2013 | markhoch
10%,"SAFE","ORDER STENCIL") I like tracking it this way because it self calculates when I input my production data. I don't have to do anything other than to look at it every day and see if one of the stencil cells have triggered, prompting me to pl
Electronics Forum | Thu Nov 07 15:33:02 EST 2013 | mleber
Below are a few photos of an ongoing issue we are having with 1 pwb style. Some of the pads appear to have contamination that appears after the selective solder step. The joints are extremely hard to rework - almost impossible. We had the joints anal
Electronics Forum | Wed Nov 13 16:48:19 EST 2013 | spoiltforchoice
I would expect any half decent machine to place 0603 parts slap bang on target to the typical defined accuracy for such parts on most machines of perhaps ~60 microns or better. Self correction during reflow is IMHO much less pronounced with lead-free
Electronics Forum | Wed Dec 18 07:22:23 EST 2013 | davlec
We have not tried VectorGuard, so I cannot comment on that specific solution. However we have been using a Tecan Genesis system for several years and are very pleased with it. Unlike the DEK solution, the tensioning is entirely mechanical so there is
Electronics Forum | Mon Jan 13 18:21:54 EST 2014 | vwhipple
A little confusion here. Are you running several boards in one pallet and the last boards are looking poor or is the issue getting worse as the day progresses (like as the pallets get warm)? - If it is the last boards in the pallet, then you may wan
Electronics Forum | Wed Feb 05 22:03:21 EST 2014 | alphatronique
Hi as said clip and and adjustment was not in cause if you look picture part was right at the good place so tape adjustment was good for all the 16 tape and have also replace all the 16 clip whit same result i have service any mydata feeder bef
Electronics Forum | Mon Nov 17 06:27:50 EST 2014 | garym4569
In the program editor on the machine, you can output a text file of the production data. You can select to output placement data, component data, and/or feeder setup for the product currently loaded on the machine. You can also do the same in the H
