Electronics Forum | Mon Jun 12 09:07:10 EDT 2006 | JimC
Flux: Getting enough- is the spray fluxer getting good through-hole penetration. Try cranking it up. Soltec spray fluxers are not really as good as Ultrasonic Systems or Sonotek ultrasonics or the new ServoJET, but should do the job. Also, try anothe
Electronics Forum | Mon Jun 12 09:08:17 EDT 2006 | Chunks
Hi Grant, Boy, how do I say this - I might have to agree with Wave Master Larry. (Yeah, yeah - I know; Davef and Dr. Shocker will "burn me" again) "We" also solder large thru-hole connectors on with a selective solder machine. They measure 4 by 8
Electronics Forum | Mon Jun 12 13:49:47 EDT 2006 | grantp
Hi, Thanks guys for all the suggestions. I am going to check what options we have for top side heating. Do people recommend we get convection for that? Also, we seem limited to 60% in the machine setup, and does anyone know how to run the top lam
Electronics Forum | Mon Jun 12 14:16:23 EDT 2006 | Kip the Expert at all Things SMT
Hi. I agree that the Soltec has weak, low-wattage preheaters, and also, the Soltec's fluxer is flippin' weak too. It doesn't do a good jab of atomizing the flux and getting good, huh-huh, penetration on the holes. I cranked up my Soltec's pressu
Electronics Forum | Tue Jun 13 04:20:21 EDT 2006 | Grant
Hi, ok, I have a bit more info after playing further with the profiling. We are getting close, but we don't have enough top side heat I think. The IR lamps just don't give enough, but we can get better connector that should help. But we have anoth
Electronics Forum | Mon Jun 12 11:53:19 EDT 2006 | Rob
No Pat, it's not the craziest piece of EU legislation - that has to go to one of the following: Common Agricultural Policy Common Fisheries Policy or my favourate - The GI list The GI list stops anyone else in Europe (& aiming for the world!) maki
Electronics Forum | Thu Jun 15 06:40:12 EDT 2006 | CL
Good Morning Paul, We are using the linear magazines as well as the old style and are processing 0402 and 0201's. I do have to say that the Agilis magazines work much better for smaller parts. Just make sure that you have the correct size clip for t
Electronics Forum | Wed Jun 21 07:44:31 EDT 2006 | amol_kane
Hi Muse, what do you mean by "with a SAC Ball and SnPb Paste the ball liquifies at a much higher heat"? Actually depending upon the ratio of solder contributed by the pad (SnPb) to the ratio of the SAC solder contributed by the BGA Ball, the SAC sold
Electronics Forum | Tue Jun 20 17:12:55 EDT 2006 | chrisgriffin
Nathan, Please don't listen to the Guru. His experience in this industry is as non-existent as his magic mine. Guru, please go somewhere else. This forum is for technical advice, not sales. For those of us in reality, it is usually best to sti
Electronics Forum | Tue Jun 27 16:29:28 EDT 2006 | Board House
There was a good artical on this in Assembly Magazine October 5, 2005 by Donald P. Cullen, Director of OEM and Assembly Applications, MacDermid Inc., Waterbury, CT Heres the Link http://www.assemblymag.com/CDA/Archives/56840a86f06c9010VgnVCM10000