Electronics Forum | Thu Jun 20 16:56:26 EDT 2019 | kahrpr
It been a long time. You need special conversion cables, the board stop has to be changed and you have to swap a bunch of connectors on a card.
Electronics Forum | Fri Jun 21 03:33:54 EDT 2019 | romford_navy
It’s now working correctly Had to re-load MMI software to get new System Files
Electronics Forum | Tue Jun 11 13:36:19 EDT 2019 | cyber_wolf
Hi, Is anyone out there using a Kolb stencil washer with N7 cleaner ? If so, could you please share your opinion on performance and consumption ? Thanks !
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Thu Jun 27 10:51:59 EDT 2019 | key
Good news we fixed the unit. The air pressure for the RS was not off. made a small adjustment for the in and the out. unit working fine.
Electronics Forum | Thu Jul 18 13:15:25 EDT 2019 | dekhead
I guess you were able to locate the RS cylinder. Assuming adjustments to RS flow controls was your resolution.
Electronics Forum | Mon Jun 17 21:32:17 EDT 2019 | reckless
We are looking for a Fuji Technician in Chicago to setup and train on a Fuji CP-642. Send PM if interested.
Electronics Forum | Wed Jun 19 01:07:32 EDT 2019 | relaycz
Drop of glue should prevent module from moving, but is not really a solution. What about pad design? Are pads on PCB themselves much larger then the ones on the module?
Electronics Forum | Wed Jun 19 02:42:26 EDT 2019 | relaycz
In my opinion, fault lies in printing or reflow. With printing - it's either too much solder paste or bad print, though I would assume that would be caught. With reflow, it could be that ramp up rate is too high.
Electronics Forum | Wed Jun 19 11:41:42 EDT 2019 | tey422
Here is a link of an article regarding the SMD rotation during reflow issue, you may find it useful. http://www.circuitnet.com/experts/86914.html