Electronics Forum | Fri Sep 15 10:00:15 EDT 2006 | Joe C.
Hello Everyone, Does anyone have any experience with an SMT right angle LED from Panasonic, part number LNJ123W8PRZ. In our experience the pattern design from the vendor was not very effective (the part swam around on the pads & flipped backwards dur
Electronics Forum | Tue Sep 19 14:52:40 EDT 2006 | bobpan
Grease every 2-6 months depending on the hours used. Dont overgrease.....and make sure you wipe off all excess grease after lubing because the grease always tends to get into the horseshoe sensors and then you will get motor error 4's untill you die!
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Wed Sep 20 12:14:08 EDT 2006 | Rob
Good question - as it is a water based flux then you are going to get a very low level of solvent evaporation, and it's hardly going to be absorbing additional water whilst sitting around. (you actually want the water (carrier element) to evaporate).
Electronics Forum | Wed Sep 20 16:27:06 EDT 2006 | proy
As we are a low volume shop, the extra handling is not too much of a concern. My biggest concern is if the flux sitting on teh board for a long time (few hours) is going to cause any problems in solderability. My thought is that it should not as it
Electronics Forum | Wed Sep 20 16:24:19 EDT 2006 | bobpan
Larry, I would suggest not changing mod-codes on a machine that you dont know very well and that should solve the damaged z-rod problem. What you should do is get someone into your company to train you on the basic's of operating the machine. The $22
Electronics Forum | Wed Sep 20 18:07:52 EDT 2006 | lheiss
It wasn't my idea to reset all the mod codes. I was just doing what the guy on the other end of the phone said. I'm working on straighting the Z-Rod now and have a new one on the way as well as a grease kit. I've only checked with one company on d
Electronics Forum | Wed Sep 20 16:01:52 EDT 2006 | jimmyjames
We recently upgraded our SMT placement equipment and are quite happy with them. One of our old SMT machines however had a glue head attached to it and we are now in the market for a standalone glue station. Our SMT placement rate is roughly 12k CPH
Electronics Forum | Thu Sep 21 13:27:09 EDT 2006 | jimmyjames
We 'bend and clip' with good old fashioned needle nose pliers and side cutters. A typical size for a run would be 20-30 boards. Many of our designs are over a decade old and are fully TSO'd (FAA standard) and we can't change anything in the design.
Electronics Forum | Mon Oct 02 11:23:04 EDT 2006 | ccapezza
EFD, Inc. manufactures adhesive dispensing equipment and may be able to offer assistance with your application. Check out our product information at http://www.efd-inc.com. We manufacture dispensing equipment ranging from manual dispensers to XYZ b
winsouce.jpg)
.gif)
