Electronics Forum | Tue Dec 01 14:44:04 EST 1998 | Terry Burnette
| Hi | I have been conducting my first reflow profiles. Most of the texts that I have read suggest soldering the thermocouples to a populated pcb. I am finding this very difficult. I have been using a high melting point (Sn5 / Pb95) solder and the
Electronics Forum | Thu Nov 12 11:16:55 EST 1998 | Dave F
| | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | Dou
Electronics Forum | Fri Nov 13 10:25:11 EST 1998 | Doug Clement
| | | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | |
Electronics Forum | Tue Oct 27 10:10:21 EST 1998 | Chrys
| | | | | | What are the key feature to look for in buying a profiling product for Reflow ? | | | | | | | | Who's is the best and how much do these systems cost ? | | | | | | | | Thanks in advance. | | | | | | | | Hi Mark, | | | | | | I am curr
Electronics Forum | Sat Oct 24 23:30:59 EDT 1998 | Pete Sorenson
| I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility | getingthe heat seal ribbon to make consistant electrical contact. | Any help
Electronics Forum | Thu Oct 22 14:39:22 EDT 1998 | Chrys
| My company is looking for higher density for card layout. One suggestion has been locating active components packaged in SOT's and SOIC's on the B-side of the card. This in turn will require wave soldering of the above mentioned components. When I
Electronics Forum | Fri Oct 16 08:47:58 EDT 1998 | Scott Cook
John, I'll throw my bit of confusion into the pot, here. Your limited floorspace, coupled with your technology mix vs. volume mix narrows the scope of your search. You don't say what your budget is, or whether you are looking for speed. I'll give y
Electronics Forum | Fri Oct 16 13:11:49 EDT 1998 | Steve A
The Kyzen product was brought to my attention from a chemist at Kester solders when I asked him what could remove no clean residue from a PCB that had been built weeks earlier. We soaked it in the Kyzen for 8 minutes and ran the board through the aq
Electronics Forum | Thu Oct 08 22:20:44 EDT 1998 | Dave F
| | | I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the rema
Electronics Forum | Fri Oct 09 04:08:45 EDT 1998 | Thomas Blesinger
| | | | I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the re