Electronics Forum | Wed Apr 20 22:06:32 EDT 2016 | ttheis
With desktop/workstation computers I am of the opinion that they should be left to run 24/7 to avoid thermal cycling daily in order to prolong their life. I have dozens of computers between my home and business and I have had good success with this f
Electronics Forum | Mon May 02 12:28:03 EDT 2016 | adamjs
Why can't you place the entire job the same day you paste it? I can. But setting up and properly cleaning the stenciling machine takes 2-3 hours. We only run one shift. If we do that every day we're spending most the time on setup+teardown. Much
Electronics Forum | Wed Jul 20 12:48:21 EDT 2016 | adamjs
Hi, is there a reason why washing "no-clean" flux residue off of boards with 1(or 2)-ethoxy-propanol is not a widespread practice? This chemical is more commonly known as Henkel/Loctite/Multicore SC01. I've long known, as I'm sure most people do, t
Electronics Forum | Wed Jul 20 14:37:40 EDT 2016 | bpoydence
I started a new job about 6 months ago, and the screen printer is an Ekra E4. I have never used one before, but have used a variety of them and I have 13 years experience mainly in surface mount. I cannot seem to get consistency out of this machine
Electronics Forum | Fri Dec 23 15:35:19 EST 2016 | aemery
Westshored; Not sure how helpful I can be as there are details missing from your description. So I will try and give you some requirements that may help us sort this out. The Speedline UPGR was UPGR-026 and 027, depending on the machine type. The
Electronics Forum | Thu Jan 26 02:14:52 EST 2017 | jgo
Hi all, Am new to SMT here. I have a very thin laminate substrate which around 120um thickess. Being that thin, warpage is constantly an issue for us. For the solder printing part, we have a number of problems. Being so thin and warped, we need t
Electronics Forum | Fri Apr 28 10:12:55 EDT 2017 | clampron
Hello M, I have been a Mirtec user for quite few years (not dating myself). I had started with the MV-2 system and sequentially upgraded to the MV-3 and now the MV-6 Omni. We had tremendous luck with the MV-3 from a programming and defect detection
Electronics Forum | Thu May 25 02:18:01 EDT 2017 | neoply
Hello all, unsure if this is a good place to discuss this or not, but I can't find many Geiger counter forums. I recently got myself a MAX5900NNEUT as the datasheet of http://www.kynix.com/uploadfiles/pdf2286/MAX5900NNEUT.pdf, and while I want to ge
Electronics Forum | Fri Jun 02 02:25:57 EDT 2017 | neoply
Hello all.Thanks for taking up your time to read my post. Especifically talking, I need to demodulate a low frequency FSK signal( betwen 120 and 140 kHz ). I already have a circuit of antenna that receive the signal and I already can sample it, but
Electronics Forum | Sat Aug 26 21:53:47 EDT 2017 | kieren
Hi Everyone. I am looking for some help with my Juki Ke750. The problem is that after booting up and then starting the home position function I receive an error as stated below Message File Error E0000: KEY=200078 STATUS=2 C:¥X750 ¥GX3ERROR。MSG