Electronics Forum | Thu Nov 03 12:52:23 EST 2005 | Amol
the only problem i see here is the neighboring components (depending upon the component density) will surely undergo a second reflow during the rework stage for the BGA. this way the only lead you will have in the BGA assembly is if you are using HA
Electronics Forum | Sat Nov 05 07:33:14 EST 2005 | milroyperera
Hi, I see that the wave angle of the wave solder machine takes a major part on soldering SMDs if they are assemlbed with glue. To avoid the shadowing effect and bridging what would be the best angel of the wave for Sn/Pb & Pb-free soldering processs
Electronics Forum | Thu Nov 10 16:15:52 EST 2005 | 1st Article
Sumote, I suggest DESCO ESD safe het gloves, these gloves have a polyester exterior fabric with woven conductive fibers to ensure static protection. Inner lining constructed of material for use in heat assembly processes, can with stand 200�F maximum
Electronics Forum | Sun Nov 27 10:42:51 EST 2005 | mika
We will be happy to help You out; if You can provide us with some information on what You need and why. There is so much on this topic, so it is almost not possible to fulfill Your needs, without knowing what exactly You are loking for. Or, perhaps Y
Electronics Forum | Thu Dec 01 14:47:25 EST 2005 | Amol Kane
Hi, I am testing some lead-free assemblies using ATC. it was suggested to me that if i do in-situ testing, then i should measure the starting resistance, and subsequent resistances values after n cycles, and when the resistance value increases by 1 o
Electronics Forum | Fri Dec 09 13:32:14 EST 2005 | jbrower
Hi Ajay, Does your company currently use any quality standards or is it made up as one goes by the QA department? You might find that using IPC 610A Acceptability of Electronic Assemblies very usefull. This manual is our base line for acceptable or
Electronics Forum | Thu Dec 08 15:29:06 EST 2005 | bpoech
Has anyone adopted Dual Lane Tape feeders in their production of SMT circuit board assemblies? Universal Instruments caries one if people are not familiar. I am looking into a smooth adoption of this into production and have been looking to gather a
Electronics Forum | Sun Jan 01 22:48:46 EST 2006 | Joseph
We are using selective soldering pallet, which the soldering flux is Interflux 2005M. We encountered the poor hole fill mainly at the heat sink components. Initially we tried to apply more heat but tend to overkill the flux activity. After some modif
Electronics Forum | Tue Jan 10 17:10:35 EST 2006 | mdemos1
JAX: Thanks for the reply. We did send one of the boards back to the bare board supplier and they do concede that it is black pad. When you inspect the assembled board under a microscope, you can easily move the entire solder joint away from the p
Electronics Forum | Mon Jan 23 13:51:27 EST 2006 | Juan
Need more info.. SMT only inspection? SMT/TH inspection? Solderability inspecting? OCR/OVT inspecting? (reading letters and number) Lots of alternate parts? Established database driven programming software? (Circuit CAM, Flexa, Assembly Expert, CIMB