Electronics Forum | Fri Feb 14 14:51:27 EST 2020 | rgduval
Hmm...that's a good point, Bilal. To tell you the truth, I'm not sure where the MOT cards are in the MY series (or if they're still using MOT cards the way the TP series did). In the TP's, they were in the computer bay on the left hand side of the
Electronics Forum | Tue Feb 18 14:46:38 EST 2020 | bilalfarooqi
Hi all, We were able to fix the issue. We replaced the MOT cards with the MOT cards in the good machine. That, however, did not resolve the issue. The issue was very basic; one of the fuses (fi fuse) located to the left of the MOT cards became open.
Electronics Forum | Tue Apr 28 09:27:53 EDT 2020 | assuredtech
On power up, push and hold the F1 key during the complete boot up, this will force the machine to boot into it's I/O menu, this allows you to verify the conditions of all of the sensors and confirm if it is waiting on an input from a sensor. Most com
Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette
Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and
Electronics Forum | Mon Aug 24 14:50:33 EDT 2020 | aurash
I'm stuck with this - if anyone knows a good technician with KE2060 expertise - please let us know. So far we checked the power going to the Z-drives, XY- drives all seems ok - no error leds on the Motor Drives (all amber) When trying to go in Ori
Electronics Forum | Tue Mar 02 12:29:52 EST 2021 | astarotf
Hi Travis H, Thank you very much for answering and helping. Apparently, but I'm not sure what the X linear bearing assembly is. The replacement part I am looking for is I believe this it
Electronics Forum | Tue Mar 02 16:05:46 EST 2021 | travishemen
The document I am using is through Universals Voyager software. It contains all the manuals, part lists, procedures, etc. It is an installed piece of software so it would be hard to share. I was able to find the pdf of this breakdown. I assume th
Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Wed Mar 03 10:14:45 EST 2021 | spoiltforchoice
I don't have one of these machines, but what kind of checks are you able to do on the linear encoders? On our Essemtec there is a dedicated diagnostic utility that gives you a plot of the encoder readout showing both the raw readout as a sort of roun
Electronics Forum | Tue Jun 29 11:46:56 EDT 2021 | stephendo
It's been a while but what about the nozzle? Is it still springy? And did you check the part data? At one place our machine would be metric or imperial depending on a visitor from HQ. If you are smashing parts on the board that isn't good and if you