Electronics Forum | Thu Apr 07 19:17:43 EDT 2022 | cbart
Good afternoon The ISI I was mentioning is interconnections solutions which is a division of Molex. a few years back we ran into a component end of life situation but had thousands of very high dollar bare boards in stock. the package was a BGA and w
Electronics Forum | Sun Apr 17 00:04:03 EDT 2022 | klauss
I am mounting 3535 Cree High-power leds with p&p machine. First nozzle picks up the led normally and then it's placed good but after 4-5 times nozzle picks up the led like at an angle. looks like it holds the led from the side edge of the dome.
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Tue May 17 01:32:34 EDT 2022 | sarason
Another method would be to do a screen dump on a Juki 2070,2080 machine, but that gets you back to the chicken and egg scenario. My program PCBSynergy doesn't reverse out the board file from a machine file while Ealead does . Also the programs EPU, F
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Mon Jan 09 16:04:45 EST 2023 | proy
We have a Koh Young 3030 3D SPI machine - this was completely working and we shipped it out to storage, and brought it back. Presently now though - the Machine controller computer which is a Unix machine has a corrupted disk drive. The Windows comp
Electronics Forum | Wed Feb 08 22:15:39 EST 2023 | stephendo
Careful with the term "vacuum sealing". You do NOT want vacuum in the MBBs. If you take out too much air you can create pockets where the moisture gets trapped. Also you can cause corners to pierce the bag. And you can even cause moisture to be pul
Electronics Forum | Fri Apr 21 07:18:40 EDT 2023 | spoiltforchoice
I had quotes for a MY100 -14 a Juki KE-1080 and an iPulse M6ez back in 2011 and at that point all those machines were about the same price with a light feeder package. The MyData however was the only one configured with smart feeders, a tray feeder a
Electronics Forum | Tue Jun 27 05:28:32 EDT 2023 | ttheis
We powered up our Advantis machine after leaving off for several months. When we powered it up went to zero it we get an error on the y1 axis during zeroing. Command move home: pattern step 0. The y negative limit is hit during homing, the axis then
Electronics Forum | Thu Jun 29 03:04:19 EDT 2023 | ttheis
The first thing we do with all machines we buy is back them up. First we backup the calibration info, then we remove the hard drive and image it to our server. If the hdd dies, we can restore it to a new one. Look on eBay for new-old stock on the har