Electronics Forum | Thu Jan 07 14:19:07 EST 2016 | hegemon
What SWAG said. We use a PCB Router exclusively for rigid flex assemblies. On a side note, we have begun to save fixturing costs by using 3D print technology to produce many of the fixtures, for both rigid and rigid flex. We can design and print l
Electronics Forum | Sun Nov 06 03:09:44 EST 2016 | muzzy
Hello. Thank you for your answer. Yes, you are right. It would be best to badmark those boards. But we, as a small contract assembler, can't throw away a 1/5 of client boards just because of damaged fiducials. Using pads and other features as fiducia
Electronics Forum | Wed Nov 02 16:36:05 EDT 2016 | ttheis
Problem was bad FCU board; replaced with FCU from another machine and swapped rom chips. Oven operates properly and communicates with PC. BTU was kind enough to supply the default usernames and passwords for wincon but they did not work. Still waiti
Electronics Forum | Mon Mar 20 10:25:30 EDT 2017 | cyber_wolf
@ Westshoredesign: Go take the top covers off your XPM's. Tell me if you see flux residue on the blower motors and the surrounding area. If you see this, grab ahold of the blower motor and rock it back and fourth. It is moves, the seals are melted o
Electronics Forum | Mon Apr 10 14:26:38 EDT 2017 | jdengler
Hi Mark, The status messages for these older UIC machines aren't always as helpful as we would like them to be. What exactly is happening? No air for the whole inserter part of the machine, or the inserter head only? It's been a while since I ha
Electronics Forum | Mon Apr 10 15:34:53 EDT 2017 | mrich208
Hey Jerry, The valve that sends air to the head of the inserter does not close when you press the "Interlock" button. If you press on the end of the solenoid with a screewdriver to force it the air makes it to the head. If doesn't seem like it is tr
Electronics Forum | Mon May 01 12:32:50 EDT 2017 | emeto
Looks like you have bad wetting. I will do in this order as it is easier to troubleshoot starting with the machine and transitioning to the PCB: 1. First clean some bare PCBs really good and try again. 2. Check thermal profile 3. Check flux - amount
Electronics Forum | Mon May 15 13:05:31 EDT 2017 | edhare
Pin holes in the gold can allow for corrosion of the underlying nickel and copper to form copper and nickel oxides on the gold surface (example - http://www.semlab.com/blog/?p=564. The corrosion can work itself all the way through the EN layer (exam
Electronics Forum | Sun Jul 02 23:39:27 EDT 2017 | bentepcb
I found that some guys in the forum will raise a question and answer the question by themself, just intend to attract others attention, and then sell their products. There's nothing wrong with selling your product, but if you intend to promote your p
Electronics Forum | Thu Oct 12 22:36:40 EDT 2017 | stefan110882
Please ost some pictures so we can see what > you're talking about. OK here an example. I'm sorry for the bad quality - The picture is cropped and only one of two pictures that I had on the phone that I could use. According to my supervisor, th