Electronics Forum | Fri Aug 27 11:27:55 EDT 1999 | Brian
I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead?
Electronics Forum | Sat Aug 28 09:23:36 EDT 1999 | Mike McMonagle
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Check out the EasyBraid website below, they carry IPC standard coupons, flux test kits and SIR meters at reasonable prices.
Electronics Forum | Mon Aug 30 16:10:10 EDT 1999 | Dave F
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Brian: We don't use an etched board. We use a special stencil, described below and print on bare copper laminate. 3 Solder Wetting Test. Recogniz
Electronics Forum | Wed Jan 31 12:59:53 EST 2018 | fluxgate
Hi Rob, I did check with the board house, and the confirmed that there was no Nickel plating, but that the silver went straight onto the copper in their immersion silver process. Interestingly I've even tested an unplated sample from that board hou
Electronics Forum | Thu Feb 01 03:02:50 EST 2018 | robl
Hi Rob, > > I did check with the board house, and > the confirmed that there was no Nickel plating, > but that the silver went straight onto the copper > in their immersion silver > process. > > Interestingly I've even tested an > unplated sam
Electronics Forum | Thu Aug 24 15:54:13 EDT 2006 | davef
It depends. What is: * Storage environment and period * Board laminate, epoxy, and copper thickness of PTH * Down stream process * Etc FR4 0.062" thick boards absorb between 0.08 to 0.1%Wt of moisture within a 24 hour period, and 0.2 to 0.23%Wt in
Electronics Forum | Sat May 17 10:38:49 EDT 2014 | sarason
I hate to say this but in all probability this wont work. I have built real strain gages and they depend on the change(Co-effiecent) of resistence with strain(or Stretch). since you are connecting you elements up with copper wire it will frm part of
Electronics Forum | Mon Oct 04 20:06:31 EDT 2004 | davef
We know SIR coupons are not ROSE coupons, but coupon boards are: * IPC-B-24 (copper and HASL, FR-4 and polyimide) * IPC-B-36 (bare copper and HASL, FR-4 and polyimide) * IPC Phoenix board (bare copper, FR-4) * IPC-B-25A (FR-4, bare copper only)
Electronics Forum | Wed Feb 23 02:20:09 EST 2000 | Roni H.
Hi, I need a wear resistance PCB finishing over bare copper (If exist!), the surface have a moving part which slides over it and bare copper as a surface is not good enough. I'll apprechiate any information. Thanks Roni
Electronics Forum | Thu Feb 17 02:49:04 EST 2000 | Roni Haviv
Hi, I need a wear resistance PCB finishing over bare copper (If exist!), the surface have a moving part which slides over it and bare copper as a surface is not good enough. I'll apprechiate any information. Thanks Roni
