Electronics Forum | Fri Mar 22 04:20:29 EDT 2013 | jlawson
Also Rehm Thermal Systems Ovens would be worth a look... They are well made, ALL stainless tunnel , 3 phase blowers, highly realiable, and they have new entry level series called VXC Series starting at 6 zones+, but based on same tech and build as t
Electronics Forum | Fri Mar 22 10:40:51 EDT 2013 | derekj
Hello all. I was hoping that maybe someone has a manual for a Omniflo 5. Build year is 1998. Photocopies would be greatly appreciated, and willing to pay. Even if we could put down a deposit, you send the manual we do the photocopy and we can send it
Electronics Forum | Mon May 20 11:19:34 EDT 2013 | jax
I don't get it... Who cares if the zones on your oven are 10° different or 100° different, if the oven you have will support it? The only thing that matters is the product you are building and the parameters in which you do it. Ramp Rate, Soak tim
Electronics Forum | Thu Jun 06 10:08:55 EDT 2013 | grauen06
We keep all moisture sensitive parts in a humidity control enviroment at our main plant, but our return/refurb products building does not have humidity control. My question: Do moisture sensitive ICs that get hand placed by our refurb/return team n
Electronics Forum | Thu Aug 08 13:11:00 EDT 2013 | shawnvike
I have a new product to build and it uses a SMD EMI board shield. I have never done this before. There are multiple components under the shield, do I place the components and then the shield and then reflow? Or do I have to reflow the components, ref
Electronics Forum | Tue Aug 13 10:22:13 EDT 2013 | mccabekev
We are seeing this the full length of the oven. We run a lot of double sided boards, so we cannot run them on the wire mesh. I checked inside the oven to ensure there was no build up of dropped parts that could block it. The temperature difference
Electronics Forum | Fri Aug 30 10:19:09 EDT 2013 | proceng1
http://i73.photobucket.com/albums/i236/djturnz/IMG_20130830_100237_874-1.jpg It is an IR receiver. Our customer does not know the manufacturer from an old assembly of theirs, but they'd like us to start building them. This is one of the parts we are
Electronics Forum | Thu Oct 03 17:20:56 EDT 2013 | bandjwet
All: We have been asked by a client to build boards that will go in to a UL-listed product. We would supply the boards and others would assemble all of the components in to the final assembly to make the finished product. If we were to provide the
Electronics Forum | Fri Nov 08 11:10:36 EST 2013 | rgduval
I'm not completely sure what you're asking, but, I can say that I've placed these parts with MyData's and Philips machines. Pick in the center of the part, and place in the center of the outline, and the terminals should line up with the pads on the
Electronics Forum | Fri Dec 20 15:38:53 EST 2013 | island2013
Aperature layout on your stencil could be a root cause as well. Home plate design aperatures have cleared this issue up for me in the past. If it's a clean product, running through the wash may get rid of quite a few of them. Also check your IPC s