Electronics Forum | Mon Mar 06 13:24:40 EST 2006 | slthomas
I would not want to be the guy responsible for a non-FDA approved eyewash in my first aid cabinet, for a lot of reasons. #1 is what could happen to someone if it went bad, #2 is what my executives would do to me for putting the shareholders at risk.
Electronics Forum | Mon Oct 02 05:51:46 EDT 2006 | dave
All, What controls do you have in place for PCB moisture control? If you had a kit of 400 and you ran out of a part which wasnot due in until 6 weeks- do you store the boards in a dry cabinet ? Vacuum seal and store on a rack? Alan...
Electronics Forum | Fri May 04 18:49:31 EDT 2007 | darby
We use Super Dry. The oldest ones are about 5 years old and we haven't had a problem.
Electronics Forum | Thu May 08 10:06:21 EDT 2008 | russ
Does anyone know of where/who to get test equipment to verify Xray cabinet is not leaking? Thanks in advance Russ
Electronics Forum | Wed Jul 09 13:12:18 EDT 2008 | josh_brubaker
Ours are catagorized under "New Machine Justification" for getting the proper equipment for the job. I might catagorize this one under "Dry Cabinet"
Electronics Forum | Wed Jun 24 07:14:26 EDT 2009 | aj
Hi all, Anyone have one of these lying around in your spares cabinet? off a Dek MK1 printer. Or where I could pick one up. Thanks in advance, aj...
Electronics Forum | Sun Nov 22 19:53:10 EST 2009 | prodrivegsr
Hi Ju Yong, The PCB are dry in an airseal cabinet(Staging Chamber) before IR Oven. The bubbles show at around body and solder joint area. You mean the moisture will create bubbles ? Able to advice the humidity and temperature that you are using in
Electronics Forum | Thu Feb 18 06:32:29 EST 2010 | nico67640
If I place a MSD level 4 open more than 8 hours in a dry cabinet
Electronics Forum | Thu Jan 12 13:18:07 EST 2012 | swag
215 to 220 deg.C peak reflow. We bake then store all PCB's in low humidity cabinets (appox. 3% RH) prior to running.
Electronics Forum | Wed Jul 13 05:17:56 EDT 2016 | salini
How the moisture is not effecting the moisture sensitive devices after board assembly solder process when kept inside a cabinet with IP 20 rated?