Electronics Forum | Mon Sep 13 15:47:44 EDT 2010 | dox
Somebody pressed the system set button and now the machine has an e-stop,lid open, and extraction error. checked the control relays and all is OK except one is not switching on. The cable comes from the FCU unit so suspect some config or settings are
Electronics Forum | Wed Dec 22 13:04:41 EST 2010 | wingding
I have a FUJI MCS-30 and no way to print from it. I need a cable that goes from the printer to the connector on the back of the computer, or an adaptor that will allow me to use my dot matrix printer. The printer is new so I don’t want to replace it
Electronics Forum | Fri May 06 10:18:43 EDT 2011 | bobpan
Hello Doug, There is no tuning up of the cyber-unit. From the symptoms you describe......sounds like the white cable that plugs into the cyber is intermittent. Maybe you can find one somewhere and try that. The cyber unit is a closed assy. and was ma
Electronics Forum | Thu Oct 27 20:37:49 EDT 2011 | tech1
the calibration error sounds like it is an electrical verifier issue. Are you testing parts before you place them? It could be that your centering electrodes are worn or dirty, or it could be the ribbon cables from the centering unit. If you are usin
Electronics Forum | Thu Jul 05 17:40:21 EDT 2012 | ck_the_flip
DaveF, What is your prediction if one tries to put a solder iron to it? Will the component bridge? I know hot-bar soldering is more common for things like Flex Circuits (with silver-filling epoxy), etc. and not so much for things where standard so
Electronics Forum | Tue Jul 17 10:09:48 EDT 2012 | cyber_wolf
Phil is on the right track. Try this.... Go into the service program, and bring up the vacuum force indicators. Manually install a spring loaded tool into the Midas head. Once the tool is in the head, press on the tip of the nozzle with your finger.
Electronics Forum | Fri Sep 07 17:03:10 EDT 2012 | burb1999
I would guess the FFX cable as metioned with the sensors inside the midas, that could of been damaged by a part or? Not a big deal to replace just remember how many turns the milar harness goes around. Also just loosen the rear screw there is a slo
Electronics Forum | Thu Sep 19 10:27:10 EDT 2013 | rgduval
I believe there is a force calibration menu option in the maintenance menu. From the main screen, choose exit to maintenance to get into the maintenance menus. If you're still having force issues afterwards, you'll want to start hunting for broke
Electronics Forum | Fri Sep 14 10:30:45 EDT 2012 | dekhead
I believe there was a software issue as well; Initially installed software (4.03) replacing existing 2.12. After that it got past the "Stack Overflow" and displayed the expected error for incorrect addressing on PCAD12... BTW solution to "vision boa
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
