Electronics Forum | Thu Aug 13 16:47:06 EDT 2015 | deanott
Thanks for your reply. I have very little documentation for the machine. Any idea where the camera voltage might be detected/measured or where the PS for the camera is located? Is it part of the camera assembly?
Electronics Forum | Thu Feb 24 23:01:30 EST 2005 | smtuser1234
One other thing to check is your PEC camera. Universal uses a jig to calibrate this camera but you could check it using this method. 1.Run about ten 0402 parts on tape with the PEC camera off and check placement. If the placement is off change the x\
Electronics Forum | Wed Aug 17 07:55:28 EDT 2005 | cyber_wolf
I had a camera go bad on my SPM machine. Of course MPM has discontinued this camera, and the upgrade to fix it cost 10K. Does anyone have any suggestion where I may be able to locate a replacement, or get it fixed ? The camera I have conveniently h
Electronics Forum | Fri Sep 09 06:08:39 EDT 2005 | geb
I think it may be the card thats causing the problem. When both machines are set to display a live image, the faulty machine shows pink/red. When their cables are pulled out of the card the working machine shows grey/noise and the faulty machine stay
Electronics Forum | Mon Mar 03 12:25:37 EST 2008 | daxman
The problem was first noticed while doing a nozzle center. The wide angle camera would not display an image. After rebooting the machine (sometimes it took several tries) the camera would work. A few months later, the wide camera would not boot at a
Electronics Forum | Tue Nov 30 06:33:44 EST 2010 | jmw
If you are using the upward camera then you probably have to put in a placement offset for each head. This only effects upward camera placements...not quadalign. This is located in: 1. machine-calibration-camera lens 2. Choose upward camera2 under "
Electronics Forum | Mon Oct 07 22:06:43 EDT 2013 | action_101
I successfully inspect solder on plcc's with angled cameras on the yestech we have. In the past I have successfully inspected for solder with angled cameras on mirtec machines for both plcc's and qfn's. Other than inspecting solder on those two types
Electronics Forum | Fri Aug 22 02:10:55 EDT 2014 | mdang
I wonder if anyone can help me with this problem. My FUJI CP65 with 0201 camera is working fine for a while. Now, it starts losing the vision on 0201 camera. The system will run for a while then I don't see the part on the part monitor when the nozzl
Electronics Forum | Wed Feb 26 11:31:42 EST 2020 | philc
I use a stereo microscope (Mantis) and find it way better for soldering/rework than a camera system, which we also have here. The camera system does NOT give you the same 3D-type of image that the Mantis does, BUT, there are times when you are inspec
Electronics Forum | Fri Sep 07 17:38:23 EDT 2007 | bentigano
Hello James. I've got a YesTech YTV-2050 system at work with one top-down camera, and 1 side-view camera for each of the four sides. I do have the side view cameras being used for automated side inspection. There are some parts with markings that are
winsouce.jpg)
