Electronics Forum | Wed Feb 11 14:55:52 EST 2015 | erezah
we received assembled PCBs with spots that look like a bleach spots all over the PS and CS . The board house said that this is normal due to flux aqueous wash process. Can it cause problems (e.g. corrosion ) in the long run or cause issues when wor
Electronics Forum | Fri Feb 13 10:10:21 EST 2015 | rgduval
I'm with Evtimov...if you've got a new assembly with a BGA (and especially if BGAs aren't an every day occurrence in your process) it should definitely be profiled. I have run BGA boards without profiling before, and got lucky...but, I wouldn't reco
Electronics Forum | Thu Feb 12 21:14:37 EST 2015 | kahrpr
They are both very good machines however Kohyoung will give you better first pass results meaning a lot less false calls and when you run the first board after initial programming you have to fix very few things. However the cost is a lot more. This
Electronics Forum | Tue Mar 03 16:27:53 EST 2015 | emeto
As Lokit mentioned, the support and spare parts are important. Support for Mirtec has always been very fast responding, but the spare parts are different story. Last two times I needed spare part it took them two weeks(parts are coming from Korea)
Electronics Forum | Fri Feb 13 12:00:21 EST 2015 | placementguy
I have extensive experience with both..I could share a list of 10 major differences, based on your manufacturing environment and the products you make, if you would like. It really matters whether you are high volume, low mix or low-med. volume, high
Electronics Forum | Tue Feb 17 13:04:14 EST 2015 | longnguyen
I am looking for the Manual and the Conveyor belt fluid cleaner for the Electrovert Bravo 8105, the conveyor belt fluid container is near the front with the brush point down to belt ( closed to the monitor ), any one know where can i buy this Manual
Electronics Forum | Wed Feb 18 10:36:44 EST 2015 | superlen
Hello, We are bringing online a UP2000 printer and are in need of some squeegees. Can anyone recommend a supplier? This is a used machine so I'm not sure if I would have to register with Speedline if I wanted to order parts from them. I just assumed
Electronics Forum | Mon Mar 16 11:40:56 EDT 2015 | swag
If it took you a long time to get it through pick and place or you had to do a lot of hand add of SMT parts, your paste can start to dry out especially on the small deposits. We've seen this time and time again. We've gotten way better at quickly p
Electronics Forum | Thu Apr 16 10:11:51 EDT 2015 | hugh_manatee
Your solder paste manufacturer’s profile is just a “guideline.” You can customize your profile to meet your product’s need. For better grain-structure (shiney-ness) try a ramp soak spike profile keeping your preheat temps very low before your reflo
Electronics Forum | Thu Feb 26 12:24:02 EST 2015 | emeto
The best test will be to X-ray BGA under 3-D X-ray. About the techniques used for BGA repair you can probably take closer look to some BGA repair stations, even though I have seen it done with hot air gun in the early days.