Electronics Forum | Tue Sep 26 16:46:39 EDT 2006 | slthomas
"I can understand the tech support thing to some extent..." Absolutely. "...but not selling parts." Bingo. As far as I can see it costs them money, so why would they do it? I find it hard to believe it's spite, but that's about all I can come u
Electronics Forum | Tue Oct 17 11:51:23 EDT 2006 | SteveT
where I can get an install disk for a Comtrol RS232/422 Interface controller? We're upgrading a PC and I need to move the controller but obviously this thing isn't going to be plug n' play, or even plug n' pray. I'm assuming there is one because I c
Electronics Forum | Wed Dec 06 23:54:24 EST 2006 | valuems
Think you will find every mpm is operating on dos base software, just in the last 2 years have they got software with windows base. The mouse is related to the version of software, and the old software requires only one model of mouse. Give up tryi
Electronics Forum | Sun Mar 25 22:21:03 EDT 2007 | sleech
Let me explain. At 125 degrees C, the oven is above the boiling point of water. It will be vaporized and eventually be vented from the oven. However at temperatures of 90 degrees c and lower the relative humidity becomes an issue. For the life of me,
Electronics Forum | Mon Mar 05 01:59:35 EST 2007 | aripa27
Dear all, I would like to know where can i find the specific models on the internet. If possible, i would like to know the website that can tell me in details about the models. I've tried browsing using the products official website but seems that
Electronics Forum | Thu Mar 08 14:30:45 EST 2007 | ratsalad
If you are in the middle of a run and can't get a replacement stencil there immediately, you can always put a little kapton tape on the bottom of the stencil to mask off a portion of the DPAK pad and reduce the paste deposit. We have had to do this
Electronics Forum | Mon Apr 23 03:54:16 EDT 2007 | mexx
Now I need to select a AOI machine. There is a problem. My company have a non-stop production process of different PCB. One manufacturing process can be 24 - 48 hours long ( about 2000 to 10000 PCB from different costumers) and so I need to find AOI
Electronics Forum | Wed Apr 25 17:44:05 EDT 2007 | Cmiller
WOW, just no innovation here. Nobody thought to sick some suction cup thinggys to is so it can place parts too and a little dispenser so it can put down paste and yea, an old convection rework wand and wow, we can do SMT and AOI. GOD, what was I thin
Electronics Forum | Tue Jun 05 10:49:31 EDT 2007 | realchunks
Hi WRIGHT, When you the standard, I assume you are talking about what kind of set-ups. If so, then RDR is right. Contact a supplier. Most sell the water and also units that can make D.I. water. It depends on your need and size of your cleaner.
Electronics Forum | Tue Jun 19 19:03:31 EDT 2007 | diesel_1t
Hi folks. If the solder is on the BGA but is not soldered at all on the pads, then you can discard BGA solder issues, by the other hand; you might be experiencing wicking due to heat is being absorbed on component so the balls on BGA are hotter than