Electronics Forum | Fri Mar 26 14:02:33 EST 2004 | russ
Patrick, can't you just post the data? I noticed it wasn't readily available on the web site. Russ
Electronics Forum | Mon Mar 29 10:01:28 EST 2004 | jdumont
Patrick, I would like to try a sample of your product. Please forward me a link or email address for where I need to go to get one. That way I can see it perform myself. Thanks Josh
Electronics Forum | Mon Mar 29 13:59:27 EST 2004 | jdumont
Well how can I correct this? Would baking the board prior to any operations help? Is this an issue I should get the PCB manufacturer involved with, or something that is common and just live with it?
Electronics Forum | Tue Mar 30 07:20:20 EST 2004 | davef
If you can rub it off, it's unlikely to be a solder mask problem. Try the "excess flux, flux contamination, solder contamination" angle.
Electronics Forum | Fri Apr 02 01:05:34 EST 2004 | Grant Petty
Hi, Thanks for the info. How clean can wave soldering get? We are looking at a carrier that masks off most of the board when we run it through the wave, so hopefully this works. Regards, Grant Blackmagic Design
Electronics Forum | Wed Mar 24 20:45:01 EST 2004 | Dreamsniper
Hi Dave, Can you elaborate more on the Saponifier system process and the surface tension during aquaeous cleaning? thanks and regards,
Electronics Forum | Wed Mar 24 08:37:32 EST 2004 | steveliu
Hi, Guys, Can anybody tell me what kind of reflow profile is best for a no clean solder paste: Ramp-Soak-Spike or Ramp-to Spike? The paste we are using is AIM 293DX2B. Thanks a lot.
Electronics Forum | Wed Mar 24 16:28:06 EST 2004 | davef
No-clean flux residues can be either cleanable or not cleanable. The not cleanable type leave a milky white residue on the solder connection after suitable soaking in water. Your flux supplier will have suggestions on the appropriate flux.
Electronics Forum | Sat Mar 27 00:36:54 EST 2004 | Eric
Hi, I'm looking for an equipment to check on all the chip and ic placement pressure. Pls advise where can i find this type of equipment. Thanks.
Electronics Forum | Mon Mar 29 11:51:55 EST 2004 | Claude_Couture
Hi all, Anyone familiar with BTU oven VIP-70. The control screen indicates that it is in IDLE mode. The recipe is running, but no heat is applied. The contactor for the heat is ON. All the electrical looks ok. I can't seem to be able to contact BTU,
