Electronics Forum | Sun Oct 18 17:34:40 EDT 2009 | emanuel
The main question is, where is the problem: With the piston, in which case I can use some air oil on the rod or even a small drop in the air tube. OR With the mechanics, specifically the sprocket in which case I am not sure oiling only without prior
Electronics Forum | Tue Oct 20 12:30:19 EDT 2009 | soudomphong
Thank you very much for your information, well said. As of right now I am not using this gantry until I can resolve this issue in a timely manner to prevent it from costly repair. Thanks again for the info.
Electronics Forum | Fri Oct 23 17:33:42 EDT 2009 | grizzy
Check that you are following the moisture sensitivity requirements for the part. I've seen the part swell underneath. You can contact me at wenroth@reconsales.com for more information. I am an 'ol reflow guy from the CM world. Wes
Electronics Forum | Fri Oct 23 12:37:44 EDT 2009 | ericg2000
sorry about the subject, it was late last night when i posted. what kind of thermocouples? i will probably be ordering type K. where can i get the protective sleeve from?
Electronics Forum | Fri Oct 23 03:52:38 EDT 2009 | linseeg
What is the different between Rogers 4403 & Rogers 4350? Can we use two different material to build a PCB? If I use Ro4403 as prepreg and Ro4350 as core what is the advantages?
Electronics Forum | Wed Oct 28 13:29:11 EDT 2009 | swag
Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.
Electronics Forum | Thu Nov 05 09:50:14 EST 2009 | adlsmt
Before you buy a manual screen printer try to do it by hand. We hand stenciled boards with 19mil pitch parts for three years with decent results, with your parts it should be simple. lay the board on a piece of ESD bubblewrap, the kind with small bub
Electronics Forum | Sun Nov 22 13:58:45 EST 2009 | tpappano
I didn't attempt to get any written guarantee, but took a leap of faith based on our various communications. The broker was also a refurb operation so I figured we could resolve any technical problems without too much trouble. At this time I'm also
Electronics Forum | Thu Oct 29 10:29:13 EDT 2009 | soporto77
Hi, I'd like to know where i can find a Matrix Tray holder cheap (Pick and Place Samsung CP45 Neo) Thank you for your help
Electronics Forum | Mon Nov 23 19:36:09 EST 2009 | oeidave
Omron Electronics provides both AOI and 3D SPI Systems. If you would like to discuss our capabilities and how we can be positioned to help you, please contact me directly.