Electronics Forum | Thu Mar 30 13:09:08 EST 2006 | bvdb
The cover tape that seals the parts into the reels on our feeders always uncovers a few parts (up to ten 0805 parts) before the part can be picked. So removing a partial reel always results in the loss of a few parts. Putting a partial reel back on
Electronics Forum | Tue Apr 25 16:42:00 EDT 2006 | russ
Sometimes you gotta do what you gotta do! We have to perform this on occasion as well. We perform this when we cannot get a board to stay free of tacoing, oilcanning, sagging or warping. (we needed a bigger preheater dimension wise) We have one no
Electronics Forum | Tue May 16 07:32:05 EDT 2006 | aj
Contaminate your Leadfree Process with WHAT? What contamination are you concerned about? Its an oven - it doesnt care what you put in it... Your main concern is that you can achieve the desired Leadfree Profile...dont be confused or concerned whe
Electronics Forum | Sat May 20 09:38:55 EDT 2006 | slthomas
"witty and provocative" And that is pretty much the perspective I see all of this guy's posts from. I don't take it seriously for a second. How can you take that author name seriously? And quoting himself is perfect if he's using new usernames for t
Electronics Forum | Wed Jun 14 01:24:14 EDT 2006 | AR
Thanks ;) We even did some product development on that one. We took a normal bar of wave soldering alloy, sawed a suitable length off it and drilled a carefully measured hole through the bit of solder. The hole is wide enough so that the blister tap
Electronics Forum | Mon Jun 26 10:55:34 EDT 2006 | cyber_wolf
Do you have a login for the support section on the Mydata website ? If not, get one. Click on MYtech, then click the article named: "Simple feeder care reduces reject rate! The component separator spring" We run alot of 0402's on the TM8FC mags wit
Electronics Forum | Wed Jul 05 16:01:53 EDT 2006 | Chunks
I agree with Grant. The MYDATA machines we had were very easy to program, adjust and as Grant states make them pick up from just about anything. The best part of them was using partial reels or strips of parts. These machine don't care about havin
Electronics Forum | Thu Jul 20 05:04:30 EDT 2006 | bing007
We had a similar problem with gold contact pads. Cleanliness is paramount. If you are using foil tensioning system, wash the foil in a stencil wash before use as the cardboard cassettes may be contaminated. Be very careful when loading into a frame f
Electronics Forum | Tue Nov 21 20:35:17 EST 2006 | billwestiet
Look USED, but be very very careful with dispensers. I would suggest getting one from a reputable used broker that is willing to do a demo on your baord with your material, and video it for you. there are only a few that will do this, most want you
Electronics Forum | Tue Nov 28 11:12:48 EST 2006 | billwestiet
The ONLY (unlikely) cause I could think of is if you are pushing the component into the solder, ending up with more solder on one side than the other. Why do you think it is the volume of solder that is causing this? By the way, there are "low tomb