Electronics Forum | Mon Jul 24 15:50:51 EDT 2023 | proceng1
I am going to be using a pressurized dispenser for Chemtronics CM1 peelable mask. I need to find a solvent that will work for flushing the system. I tried Xylene that we have here and it does ok, but not as good as I'd hoped. It works very well fo
Electronics Forum | Tue Jul 25 13:46:13 EDT 2023 | markhoch
I'm curious who may be currently using Automated Mobile Robots (AMRs) or Automated Guided Vehicles (AGVs) in production. I've seen a few companies using them to transport SMT parts from the warehouse to the SMT Line. I'm wondering what others are doi
Electronics Forum | Fri Jul 28 20:45:06 EDT 2023 | calebcsmt
What is the main considerations when comparing if production should use AOI vs Manual inspection? Is it only volume/time based? (of course assuming the reliability of automation is as good, if not better than humans) So long as AOI can produce reli
Electronics Forum | Mon Jul 31 06:50:43 EDT 2023 | sophyluo1985
Contact our GOLDLAND company to make a reasonable plan for you, UIC THT machine, we have a professional team, please try to contact us, I have told my team, you can send your information requirements to him, he Please submit your name to Quinn Luo, a
Electronics Forum | Mon Jul 31 18:17:03 EDT 2023 | emeto
This is more lawyer stuff than engineering. In occasion like this one, it is probably time to open conversation around testing and hidden joints checks. In 21st century to perform only visual inspection is not a serious process, unless it is a very s
Electronics Forum | Mon Jul 31 18:45:04 EDT 2023 | calebcsmt
But what would the general basis be in the industry or at least the expectation, when not testing the unit? At least from what I've seen, 70%+ of customers don't request any type of testing and only need visual inspections... so if an assembly fails
Electronics Forum | Wed Aug 02 02:02:12 EDT 2023 | ttheis
Of the few contract jobs that we ever took one of them was with smt pogo pins. Alignment was poor and most were crooked. Probably could have been resolved with less paste and tuning the process but customer was frustrated that their design ended up w
Electronics Forum | Wed Aug 02 06:48:56 EDT 2023 | kirill
Use T5 solder paste Make sure you dont have too much paste, usually 1 time printing instead of 2. Make sure the component is baked before production. Re-check your profile on the reflow. Could be also a bad pcb edit, nothing you can do there.
Electronics Forum | Mon Aug 07 20:43:42 EDT 2023 | smith88
I am looking for some tips of the trade with solder charges. I am using recommended reflow profile in the oven and I am seeing insufficient fill per IPC, and sometimes insufficient end joint. I have tried dipping them in flux also. What are you a
Electronics Forum | Tue Aug 08 12:49:33 EDT 2023 | serge_pirog
I ask for advice on starting wave soldering machine. The soldering machine is not new. Are there guidelines for properly loading solder into a bath and more. I also ask you to recommend an alloy. What do you think about Alpha Sn Plus 07 or SN100C(Sn
