Electronics Forum | Fri Sep 05 08:28:18 EDT 2003 | pioneertechnology
Hello We have several BD12's but I do not understand what you mean by calibration data. The machines we have, all come with the following disks HRX-11, SYSTEM, IPDATA. If you are missing any disks you can contact KME with the serial of the machine
Electronics Forum | Mon Sep 08 02:05:19 EDT 2003 | CALVERA
Hello Terry, Thank you for reply. Data what we lost are in the memory. Unfortunately we bought second hand machine and for this machine was include only system disk. Around my country region is support from PANASONIC quite far way and not so flexible
Electronics Forum | Tue Sep 09 09:25:29 EDT 2003 | james
What about making the customer drawing or parts > list with their rev as a part number on your > parts list? Example: (455556 rev X) would be a > part number on your parts list. What about keeping their revision as A, B, C and in your system it
Electronics Forum | Wed Sep 10 12:56:09 EDT 2003 | davef
Intermetallic compounds [IMC]: * Form during the alloying process of some metals. In soldering these are Sn, Ni, Ag, Cu, Au. * Do not accept solder. * Increase in depth in logarithmic proportion to both time and temperature. [So during the solder
Electronics Forum | Tue Sep 09 15:32:24 EDT 2003 | mantis
We have also seen A similar issue were by the pad would completly come away from the bga land , when lightly scratched with your finger.These boards hadnt even been through our process yet and where fresh out of the pack.These issue was seen at incom
Electronics Forum | Wed Sep 10 02:47:49 EDT 2003 | Dennis O'Donnelll
This is a problem of contamination in the plating bath. Most prominent with white tin and some gold over nickel plating processes. Rather than argue with your vendor over the issue, and to avoid future recurring problems, I use either HASL or elect
Electronics Forum | Wed Sep 10 10:25:48 EDT 2003 | r_astom
Jan, Please see our webpage regarding these programs for further details. http://www3.uic.com/__852568c80050acb1.nsf/0/f5455502658b71cc852569ca0045b8cd?OpenDocument The part number for the refurbished Unit Drive in question is 630 111 8123. Also,
Electronics Forum | Tue Sep 16 09:29:19 EDT 2003 | Graeme
Jan When you fit these new unit drivers check to see if the software level is the same as what is in the remaining unit drivers, as if it is not you will find that there is a steady failure of other exsisting unit drivers.If the software level in the
Electronics Forum | Thu Sep 11 23:50:51 EDT 2003 | Dean
Epoxy is hydroscopic. A cavity will form when the cure furnace reaches the boiling point of water. The steam expansion creates the pocket. It can be large enough to be filled with molten solder from the wave machine and cause a hard short under th
Electronics Forum | Tue Sep 16 09:59:26 EDT 2003 | James
I am having a problem with SOT23 moving off their pads during reflow. We did not have this problem yesterday. On the pads and surrounding area looks like a lot of flux spatter. I looked through the threads but they didnt help me much. I know what 3
winsouce.jpg)
