Electronics Forum | Tue Nov 23 18:59:14 EST 2021 | kumarb
Hi. To add to your homework... 1) RPS are from the former team that developed the ACE KISS product line. 2) From brief chats, NORDSON is still building the last versions of the ACE KISS designs while RPS has continued to advance the tool. 3) Anoth
Electronics Forum | Sun Nov 28 02:23:38 EST 2021 | tueftler
Hi there. I have an Ipulse M1 mounting mashine. For that i have PS84 and F1 Feeders. Now i have a strange behavior with my new F1-16 feeder. The machine dont had the F1-16 feeder type on its library. So i have insert it by myself. The problem is, th
Electronics Forum | Mon Dec 06 14:44:41 EST 2021 | dwl
1 to 1 stencil aperture to pad should be fine on the gull leads, and yield 100% coverage with leaded solder. The thermal pad is going to be a challenge though, if you truly need 100% coverage. There will be out gassing from the flux and this will nee
Electronics Forum | Thu Dec 09 12:29:39 EST 2021 | stephendo
With the bottom followed by the top set up, how do you even come close to balancing that? For a lot of boards that I have seen you would need five or more top lines just to handle one bottom line. Or have the bottom line on a very low duty cycle. B
Electronics Forum | Wed Dec 29 05:58:04 EST 2021 | sophyluo1985
According to the normal theory and the feedback of our other customers, maintenance is divided into 4 ways. (Depending on the environment of your production workshop, the work head is generally inspected monthly) 1. Daily maintenance: Clean the surfa
Electronics Forum | Wed Dec 22 17:49:06 EST 2021 | mihai_voivod
I have this part: 142-1711-801 (Emerson). It is an SMT/TH part. https://www.digikey.com/en/products/detail/cinch-connectivity-solutions-johnson/142-1711-801/9992851 I want to reflow the part instead of hand soldering and/or reworking the solder jo
Electronics Forum | Mon Jan 10 03:45:23 EST 2022 | proy
YES there is an IPC target/acceptable spec In general terms the barrel thickness in the hole should be 1 mil (thou). IPC has an allowable limit lower around .75 with some other factors. I have been checking barrel plating on all incoming boards since
Electronics Forum | Mon Jan 10 10:46:36 EST 2022 | spoiltforchoice
I don't know about your Vib feeders, but on mine the intended way to use them is to have a custom piece fitted at the pick end of the tube for the SOIC shape you are feeding. While it is difficult and or expensive to buy all the possible official one
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Mon Jan 17 15:44:28 EST 2022 | sirgrumpsalot
Hi everyone Would like to know if there are any owners of contract manufacturers who would like to have an open discussion around processes and procedures etc so we can discuss how to improve. Ideally if we are not in the same geographic area so we
