Electronics Forum | Fri Apr 10 07:52:16 EDT 2009 | davef
On cure checking, we have this undated note from Jack Crawford at IPC * IPC-SM-840C "Qualification and Performance of Permanent Solder Mask" has several Test Methods for different types of solder resist material, but probably the only applicable one
Electronics Forum | Tue Apr 28 21:48:50 EDT 2009 | davef
Confirm the source of the issue. Run a coalescence test on both lots of paste. A simple coalescence test can quickly determine the condition of solder paste after prolonged use. Simply print a small disk [around 4-5mm diameter and 0.2mm thick - a bu
Electronics Forum | Mon May 04 14:24:12 EDT 2009 | jimmyboz
Ok, So, If all the servo amps on H1 remained on H1 and the amp you changed is on H2, I have to guess the shifting on H1 is unrelated to the servo prob. Is the shifting unsolderable? if it just looks bad but will reflow, it may have been occurring f
Electronics Forum | Mon May 25 08:37:28 EDT 2009 | d0min0
Hello, recently we changed supplier of the LF BGA, we did corossection and now have doubts... previous BGA specs : pitch 1mm, ball diameter 0.6mm future BGA specs : pitch 1mm, ball diameter 0.4mm on the crossecrion we found that one of the ball seem
Electronics Forum | Mon Aug 24 13:12:28 EDT 2009 | ghepo
OK Eric, maybe you're right. My suggestion is to proceed by exclusion. First perform the tape test. Is easy and without costs. You have used many similar PCB without problem, but from the same vendor ? Is my experience that in similar cases the qua
Electronics Forum | Tue Sep 01 12:47:37 EDT 2009 | rodrigo
Hi all, Our IPII just developed yet another issue. The PCB goes in the conveyor and when in the loader, the lifter goes up and after a few seconds I get a lifter cycle alarm error. I checked the in/out screen and when I make the lifter go up, the se
Electronics Forum | Fri Sep 04 02:09:03 EDT 2009 | sachu_70
Hi Walter, Do you refer to a sprayfluxer operation? The problem seems to be a parameter setting issue. 1. Ensure the wide angle spray reaches PCB with optimum jet pressure. You could pass a glass plate to understand flux coverage and view Jet pressur
Electronics Forum | Thu Sep 24 18:57:03 EDT 2009 | davef
From "siliconfareast.com": Basic Die Cracking FA Flow 1) Failure Information/Device and Lot History Review. Understand the customer's description of the failure, i.e., the failure mode, where it was encountered, what conditions the sample was subject
Electronics Forum | Thu Oct 01 07:03:55 EDT 2009 | davef
We doubt that Humiseal 1A33 is causing opens in your assemblies. We'd guess the opens occur earlier in the process, but are not hard failures. So, you pass your tests. When applied, the conformal coat flows into the gap in the ball crack and insulate
Electronics Forum | Wed Nov 04 05:58:45 EST 2009 | jeffreyj
Thanks for suggesting the GSM-1, Deni. There is a dealer not too far from us that has one in stock so I'm going to go check it out today or tomorrow. Got a few quick questions for you: 1. can you load cut tape onto the feeders, or only reels? 2. how
.gif)
winsouce.jpg)