Electronics Forum | Fri Nov 18 15:06:44 EST 2011 | jeffharley
Have you checked each heater rod with a fluke temp. meter or similar to make sure that the elements are in fact heating up? Make sure you have voltage to all heater rods. Check to see what the plc controller is set at. Hope this helps.
Electronics Forum | Fri Mar 09 05:06:09 EST 2012 | grahamcooper22
Is your solder paste deposit drying out? Or if the paste deposit is small or there is insufficient paste then the tack between the device and paste will be poor so it can easily come out of the paste during its placement or placement of other parts.
Electronics Forum | Tue Mar 27 15:49:54 EDT 2012 | bradlanger
Try Re-seating the card that connects the ISA slot from the computer mother board to the I/O Dpram card. It may be worth checking the ISA card for bad solder joints. The computer mother board could be going bad. Check for vented electrolytic caps. Ho
Electronics Forum | Mon May 14 17:07:05 EDT 2012 | davef
The geeks think that an invalid email address is registered to you. Check your 'manage account' [top of the page, left next to the guy that looks as if he's wearing a carpet] to make sure that your contact information is current. On reading this, pl
Electronics Forum | Fri Jun 01 08:02:40 EDT 2012 | mlevesque
Hello everyone! We check for a new AOI system. I know a Mirtec machine (MV-2HTL), but this time we check for the MV-2GT or MV-3L. I got a presentation about the Aleader AOI and it seems to be good machine. Anyone know somethings about it? What a
Electronics Forum | Tue Jul 17 09:10:28 EDT 2012 | dontfeedphils
You can enter the service program for the MyData, can't remember exactly how, you have to exit out of tpsys to the command prompt and type service or something along those lines. Then you can check the raw numbers for vacuum and force on the Midas h
Electronics Forum | Wed Nov 07 06:47:52 EST 2012 | leeg
I am having issues whereby a zone on my heller oven goes through a stage whereby it never seems to stabilise, I have checked the blower motor, changed the SSR and my next step will be to check the heater element, does anyone have any idea what type o
Electronics Forum | Tue Jan 15 22:33:32 EST 2013 | boardhouse
Hi Samuel, The issue your seeing is caused by lack of control of your board shops Immersion gold plating line. I would reject the order back to them. Their gold line baths need to be checked or they had a poor rinse after nickel plate before adding
Electronics Forum | Mon Mar 18 07:32:18 EDT 2013 | stephendo
It's been a long time but one thing I remember from those machines that about 50% of the time the error codes were a wild goose chase. At this point forget what the error code says. Can you move the head? Have you checked the servo cards? Is there
Electronics Forum | Tue Jul 30 12:06:20 EDT 2013 | JB
I've checked the sensors and they look ok, I'm guessing its the plc-program then. If you get it working i'd be interested in knowing how to do it to ours. Already checked with Nutek and the manual is quite expensive so I guess we'll do with out it.