Electronics Forum | Fri Jul 04 21:09:04 EDT 2003 | ramanandkini
I have a CEM-1 PCB board with 35 microns copper. This is PCB is finished with SMOBC+HALS. We do solder SMT LEDs, but till date we do not have problems that you have listed. The LEDs are good & bright. It even passed high & low temp cycle tests (-40 t
Electronics Forum | Thu Sep 18 15:29:59 EDT 2003 | Gabriele
Hi all, by reading along those thread (SOT23) and Tan outgassing I learned plenty of things. My first time approacing this kind of Q$A Forum, very intesting tech communication way. Any way, the path of magnetism effect was chosen when time ago we met
Electronics Forum | Fri Sep 24 11:08:13 EDT 2004 | davef
We're not sure what you mean by temperature sensitive components. From an assembly process stand-point, every component we use is temperature sensitive to one level or another. More specifically, some of our products use polyphenylene sulfide (PPS)
Electronics Forum | Thu Jan 13 07:29:49 EST 2005 | Grant
Hi, It's both really, and we are doing higher volume of current products, but new products are increasing in component count, mostly passives. We have analog on our products, and this uses a lot of passives, plus each semiconductor needs decoupling
Electronics Forum | Tue Jun 13 09:14:37 EDT 2006 | samir
As I mentioned in another thread, I've always been one to flux the living crap out of a board until the ICT guys start yelling at me, which actually did happen last week. I had a little oriental guy (an immigrant to Riyadh from Vietnam), clicking an
Electronics Forum | Thu Mar 22 12:46:43 EDT 2007 | Hussman
Those Panasonic machines should be able to tell ya pick-up rates form the feeders and shape code errors (components it doesn't recognize). You will probably get a more pick-up errors than anything else. Most of this is due to plastic tape versus pa
Electronics Forum | Mon Mar 26 13:49:16 EDT 2007 | grantp
Hi, I don't know anyone who uses Mancorp, and apart from this forum have never heard of them. I guess the big problem I faced when getting into SMT is trying to find a machine that could do what we wanted at a good cost. I originally purchased MYD
Electronics Forum | Thu May 17 21:50:29 EDT 2007 | jeremyl
Hi All. We are a tiny startup company developing an IC in a flip-chip CSP package. We find ourselves in need of being able to remove and replace (ie rework) our chip on a characterization board. The board will not be big and the chip is very small
Electronics Forum | Mon Sep 17 17:33:38 EDT 2012 | kq702
thank you for your reply. I felt like I was using too much heat but I thought it would not work unless I did so. I did not suspect a cold solder joint, however I did another test on a scrap board. I heated the board without my clamps attached (I put
Electronics Forum | Sun Feb 22 15:46:09 EST 2015 | slave2anubis
Hi, my name is Dacian, and i run a mobile phone repair shop in Timisoara, Romania. Lately we decided to do more advance motherboard repair jobs, and a big problem that we have is, cleaning the board after we remove the chips. We repair manly iPhone,