Electronics Forum | Thu Oct 14 07:55:48 EDT 1999 | JohnW
Sorry Dave should have said... At the mo all my data is for no clean processes using both matte and gloss finishes. That doesn't mean your feedback has to be limited to this area, I'm really trying to find out what the rest of the world are doing if
Electronics Forum | Tue Apr 06 17:27:24 EDT 1999 | Kennyv
I am getting ready to purchase a spray fluxing system for a no-clean process. I have narrowed it down to the Nordson or Dover system. Does anyone have any experience with either. If so can you relate with me. I am a little leary of the Nordson be
Electronics Forum | Mon Jan 18 11:19:18 EST 1999 | Ken Daniels
I have a severe problem with flux residue being drawn up the vent ducts of my reflow oven. This residue reaches a critical mass then begins to flow down the ducts and becomes very messy. I run a no-clean process and use IR oven. Has anyone else out
Electronics Forum | Wed Aug 29 20:48:09 EDT 2001 | Jones
I know this is not the answer to your question but it may help until you get the right cleaning process in place. I have found that kneading the paste with 3-4 double strokes during the first print has aided in bring our defective ppm down somewhat.
Electronics Forum | Wed Aug 14 16:34:46 EDT 2002 | ksfacinelli
I have a PCB laminate that is 1 1/2 years old and showing signs of poor solderability. The NC flux I am using will not breakdown the oxides. During hand soldering the pads do not take solder. I am trying alternative fluxes and have seen an improve
Electronics Forum | Wed Apr 23 08:44:06 EDT 2003 | davef
So, steaming your boards in a box makes them cleaner? Never heard of that. What are you removing from your boards? The longer the conveyor in your washer, the faster you can run it, but then again it's longer. Consider that a saponifier or someth
Electronics Forum | Mon Nov 15 08:41:34 EST 2010 | babe7362000
Has anyone else had failures with Leds from EOI? The part number is EOZ-ZARNCD0-DG. We are using a lead free no clean process using SAC305 solder. These are thru hole parts and our max temp is 244 for 3 seconds. Please if anyone else had issues
Electronics Forum | Mon Apr 29 15:48:12 EDT 2013 | dontfeedphils
I'm looking into labeling solutions for our PCB's. I've got it narrowed down to the label and the ribbon to match our thermal and cleaning processes, now I'm looking into the best overall industrial style printers. What brand and model thermal prin
Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces
Electronics Forum | Mon May 18 15:30:07 EDT 2020 | dwl
I've seen that before, had to switch to a no clean process for those boards. It's not typical for ferrites, usually its safe to wash them. Out of curiosity does the Data sheet say anything about whether or not they can be washed? In my case we lear
