Electronics Forum | Thu Dec 20 23:56:35 EST 2007 | isd_jwendell
I run a prototype/small-run shop, so I'll include some recommendations too: 1) Don't buy a machine for just what you are doing today. Once you get into this field you will find demand to do more. 2) Don't scrimp on the stencil & machine. You will spe
Electronics Forum | Thu Feb 28 21:01:09 EST 2008 | davef
Tony: Thanks posting information about your experience with strippers. First, why did you need to strip the entire board? Next, please clarify the following points to expand our knowledge of using Humiseal 1063 Stripper: * How long was the conforma
Electronics Forum | Thu Apr 17 10:44:24 EDT 2008 | rculpepp
I'd suspect contamination also, possibly from the board supplier. Sr. Tech's post mentioned what looks like a blister on the board, in the upper right of the Q19 photo. This could very well be a contaminate from the PWB fab shop. I've seen similar pr
Electronics Forum | Tue Aug 26 15:39:49 EDT 2008 | kpm135
I am not positive about this but I have been told that you cannot use acrylic and urethane coatings in systems that have had silicone run through them. It was explained to me that you can never fully get the silicone out of the existing system and th
Electronics Forum | Sun Apr 26 08:36:55 EDT 2009 | davef
First, in direct answer to your question, DOE printer setup variables (MPM): * Squeegee speed: 0.5 to 1.0 in/sec * Pressure (metal): 1lb/in of blade * Pressure (plastic): 1.6-3 lb/in Second, supprting earlier responses, most people monitor paste hei
Electronics Forum | Wed Sep 02 16:41:44 EDT 2009 | pcbcleaning
Advanced Cleaning Solutions is a Johnstown, PA based electronic manufacturing service provider (EMS) with more than 3,500 square feet of ESD safe facilities. Our services include precision PCB cleaning and ionic cleanliness testing/verification usin
Electronics Forum | Fri Sep 18 11:23:32 EDT 2009 | isd_jwendell
I know nothing about Xbox specific rework, but have a lot of experience with PCB repairs. "...maybe think its a bad idea now not knowing what im doing" Don't get discouraged, it's a learning process. If it was that easy everyone would be doing it.
Electronics Forum | Mon Apr 19 15:45:21 EDT 2010 | dwonch
Thanks to all for your input. We did have a third party do an analysis on boards from the first shop. They were shipped directly from the board shop to eliminate the possibility that we could contaminate them. The third party (Forsite) did find Sili
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Sun Mar 04 02:39:27 EST 2012 | eadthem
I don't have our DEK printer part numbers memorized, In general we have a older machine running NT4.0 . It has 2Di inspection but we never use it because you can only inspect/setup 1 camera shot at once, making for very long programming. Our newer D