Electronics Forum | Tue Jul 06 01:35:11 EDT 2004 | SSS
Dear Sir, We have a urgent requirement of conformal coating. Please let us know who are the suppplier available in india. And what is the process to do the same. 1. What is critical point 2. What machinery required 3. Process of doing Conformal Coat
Electronics Forum | Sat Aug 07 02:28:20 EDT 2010 | raghu
We have PVA 350 benchtop dispensing equipement with humiseal 1A33 CC material. is there any moisture measurement process in conformal coating material?
Electronics Forum | Mon Jan 26 19:51:48 EST 2004 | davef
You should be able to obtain a smooth finish. A "glass-like finish" is in part a function of the coating material, assuming good process. When we see "orange peel" conformal coating, we think moisture from the spray room environment, conpressor, et
Electronics Forum | Fri Dec 10 12:24:46 EST 2010 | davef
Causes of dewetting in conformal coating. Factors that influence dewetting usually involve non-ionic contamination such as: * Residues from board manufacture including silicone surfactants from solder resist & HASL rinse contamination * Component res
Electronics Forum | Sun Apr 10 03:25:35 EDT 2005 | Peter
Normally, some conformal coatings do not have very good wetting properties, that should be basic function of a good coating material (the same reqirement as avoid bubbles during coating process)! For UV curing conformal coatings, you can try Lackwe
Electronics Forum | Mon Apr 23 16:34:41 EDT 2007 | davef
Well then, maybe it's an incompatibilty between the soldermask and the coating, possibly due to undercuring of the soldermask. Thoughts are: * Some suppliers provide their thoughts on the compatibility of their product with other suppliers. For ins
Electronics Forum | Thu Jan 13 11:12:54 EST 2000 | jacqueline coia
Does anyone conformally coat PCBs that have been processed with a no-clean solder paste? Any comments on this subject would be appreciated. Cheers
Electronics Forum | Wed Mar 11 11:05:06 EST 1998 | Earl Moon
| I am having a problem with Entek coated boards. The solder past seem to just ball up on the pads. I had no problems with the board when it was hot air leveled. The board is double sided surface mount. I have tried adjusting the oven profiles mak
Electronics Forum | Sun Mar 15 23:58:01 EST 1998 | Phill Hunter
| | I am having a problem with Entek coated boards. The solder past seem to just ball up on the pads. I had no problems with the board when it was hot air leveled. The board is double sided surface mount. I have tried adjusting the oven profiles m
Electronics Forum | Thu Jan 13 15:19:51 EST 2000 | Dave F
Hey Jack: It's certainly "do-able." Conformal coating adhesion testing was done as part of the "Evaluation of Low Residue Soldering for Military and Commercial Applications: A Report from the Low Residue Soldering Task Force," published by Sandia Na
