Electronics Forum | Sat Jul 18 05:01:44 EDT 2009 | emanuel
It was my mistake, I was talking about the off line VIOS, not Gemline. While on the machine a SPECIALIST code should be entered, on the computer this code is TRAINING - for whoever looks for it
Electronics Forum | Thu Sep 30 17:10:36 EDT 2010 | jeremie
You would still need a valid PDC (Product Delivery Code), only obtainable from Philips/Assembleon, to enable the software regardless. Unless you still have these codes the software will be useless to you.
Electronics Forum | Mon Nov 07 13:52:10 EST 2011 | leemeyer
Can anyone supply me with the default MOD codes for a Quad 2C. I have recently picked up a used one and am having trouble getting to run properly. All I have is codes for a 4C. Thanks
Electronics Forum | Mon Nov 07 14:15:02 EST 2011 | bobpan
There are different sets of mod codes depending on the firmware version on the machine. One of the function codes can tell you what firmware you have and if its quadalign or cyberoptics. Re-post and maybe i will have the version you need.
Electronics Forum | Thu Sep 06 14:13:52 EDT 2012 | ericrr
Does anybody have the marking code for for a capacitor this one has "EG84" marked on it. I am getting a bit of list mainly for resistors, most capacitors are blank that we get. But dont have a "letter-letter-number-number" code
Electronics Forum | Thu Sep 20 12:49:03 EDT 2012 | JB
Ok, Think I have got it now. After finding the last letter is a batch code or something, I found "The SMD Code Book" and it looks like it is MMSZ4703-V-GS08. I'll wait to see what the components turn up looking like.
Electronics Forum | Fri Sep 28 17:39:44 EDT 2012 | hishamuddinjohari
Hi, I cannot find the following SMD semiconductor marking code 'H890' somebody help me
Electronics Forum | Thu Dec 06 23:34:24 EST 2012 | Mike Konrad
Calibration solution: http://store.aqueoustech.com/ProductDetails.asp?ProductCode=Z1157 Test solution: http://store.aqueoustech.com/ProductDetails.asp?ProductCode=Z1155 -Mike Konrad
Electronics Forum | Wed Jul 16 19:38:28 EDT 2014 | garym4569
What is the base cost of an inline pcb etcher? Specs: fiducial alignment, smema interface, 400mm x 400mm marking area. Will be used to mark panel 2d codes, pcb array 2d codes, and human readable. Thanks Gm
Electronics Forum | Wed May 13 16:09:17 EDT 2015 | ttheis
After about 5 minutes of trying different code combinations I found it- hold simultaneously: F1 - Left - Down - Right FYI the setup menu pass code is: F2 - Left - Up - Down
.png)