Electronics Forum | Wed Aug 30 23:45:28 EDT 2000 | Ramon I Garcia C
Hi friends; Steve I'm using flux Kester 959, my top temperature is 187 celcius degrees, my e-mail is ramigary@smtnet.com, Travis I'll check the pcb for contamination, but how may I clean the pcb? may I use alcohol? Nance I cleaned the pipes of the
Electronics Forum | Thu Aug 31 14:27:23 EDT 2000 | Travis Slaughter
How to clean a contaminated board would depend on what it�s contaminated by, alcohol may be just the thing. If there is bare copper that has corroded that could be more of a problem, or maybe not if its due to poor tinning by the board house you coul
Electronics Forum | Fri Aug 25 18:27:45 EDT 2000 | Dave F
who makes the best conveyor?? - g cronin 10:50:56 05/15/2000 2 One used conveyor supplier is => Tech-Mation International 952 Alton Parkway Irondale, Al 35210 205-833-4277 (fax) 4377 Phil Higgins, Mathew Bennett (sales) Eric Ford (sales) tiusa@bell
Electronics Forum | Thu Aug 31 00:07:24 EDT 2000 | Ramon I Garcia C
I Kyung: I'm not sure if we are working with PIHR but we insert some pines in a PCB with a pin inserter machine, after that we run this pcb in a screen printer and put over its solder paste, and then run in a chip shooter and then IC placer and f
Electronics Forum | Mon Jul 31 15:10:18 EDT 2000 | Kevin Hamby
We are looking for a small wave or infared solder station to solder 4" X 8" flat, thru hole circuit boards, in small qty's. Do you have any suggestions? Sincerely, Kevin Hamby V.P. Tech. Engineering/Sales Intech Assembly Solutions 54900 Pine Crest
Electronics Forum | Tue Jul 25 20:46:01 EDT 2000 | Dave F
Vicki: The other responders make good points. Taking a slightly different, slightly more aggressive tact, you might try something like this: * Click on ... http://www.ssafl.com/bat_prod.htm ... and buy a unit of the proper size to fit your stature
Electronics Forum | Fri Jun 30 15:12:55 EDT 2000 | John Thorup
Hi Walter It might be a stupid question but have you tried cal comp? This is a current model and they shouldn't have any trouble supporting it. www.GTCOcalcomp.com Did you buy it with the Mydata? Most of their options have to be activated with a "se
Electronics Forum | Mon Jun 19 21:37:14 EDT 2000 | Dave F
Mike: Look a the Hadco DFM manual ( http://www.hadco.com/ ) Yano if you�re lookin� for uniformly smooth (not silky smooth) board edges, have you considered scoring to separate your boards? Scoring has: * Minuses (straight lines only, stress on so
Electronics Forum | Mon Jun 12 10:11:43 EDT 2000 | Neil Peaslee
Steve, Thanks for notifying us of the broken link. Unfortunately, the destination that the link points to is not on the SMTnet site. The paper that you are searching for resides on the ITM, Inc. site and their site appears to be down at this time. If
Electronics Forum | Mon Jun 12 10:11:45 EDT 2000 | Neil Peaslee
Steve, Thanks for notifying us of the broken link. Unfortunately, the destination that the link points to is not on the SMTnet site. The paper that you are searching for resides on the ITM, Inc. site and their site appears to be down at this time. If