Electronics Forum | Wed Mar 02 06:19:03 EST 2005 | pjc
Go to http://www.ipc.org and look up IPC-7351 - Generic Requirements for Surface Mount Land Pattern and Design Standard The successor to the IPC-SM-782A is here! The document covers land pattern design for all types of passive and active components
Electronics Forum | Fri Mar 04 15:22:17 EST 2005 | russ
Glad to hear a little success from ya Duckmann! i have stenciled mask in the past and I can tell you that stencils are expensive. They are basically a step stencil, you will need full thickness for the area(s) you are going to apply mask and you wi
Electronics Forum | Thu Mar 10 09:13:15 EST 2005 | davef
From http://www.IPC.org ... IPC-7351 - Generic Requirements for Surface Mount Land Pattern and Design Standard The successor to the IPC-SM-782A is here! The document covers land pattern design for all types of passive and active components, includ
Electronics Forum | Sun Apr 03 00:18:47 EST 2005 | Haran
What is the minimum pitch for PTH component not tend to have solder shorts during wave soldering process.
Electronics Forum | Mon Apr 04 08:41:09 EDT 2005 | davef
It depends on the component and the land, but 0.1 inch is safe.
Electronics Forum | Sun Apr 03 00:37:57 EST 2005 | Andrew
Does anyone have the matrix of Component Lead finish and the comparison/advantages/disadvantages between all of them?
Electronics Forum | Mon Apr 04 09:14:52 EDT 2005 | Andrew
Dave,I am looking on Component Lead Plating finish not the PCB finish.Appreciate if someone can share.
Electronics Forum | Mon Apr 18 21:20:34 EDT 2005 | Thaqalain Mahdi
I am confused, please do line calculation to show that 01005"=0402mm
Electronics Forum | Wed Apr 20 18:24:57 EDT 2005 | russ
This is why is said it should be called an 0503 in mm. The 0603 in mm does not make sense and confuses the issue. Russ
Electronics Forum | Thu Apr 21 18:12:41 EDT 2005 | thaqalain
Good Frank,Right.
