Electronics Forum | Fri Jan 22 10:17:47 EST 1999 | LeeAnne
I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the coa
Electronics Forum | Fri Apr 17 08:52:03 EDT 2015 | charliedci
Thanks for the info Sarason. The UVCL is a Urethane. Did not want that hard of finish (for solder rework issues). We like the Acrylic as acetone will remove cured material for solder rework.
Electronics Forum | Fri Jan 22 14:31:14 EST 1999 | Dave F
| I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the c
Electronics Forum | Sat Jan 23 07:08:54 EST 1999 | Graham Naisbitt
| I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the c
Electronics Forum | Wed Jan 27 09:00:56 EST 1999 | Chris Fontaine
| | I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the
Electronics Forum | Mon Oct 03 21:02:23 EDT 2016 | rwd
I am doing some rework to my CCA. I then need to conformal coat the board. I'm using Humiseal 1A33 GEL and my jumper wires are teflon coated. I understand the chemical interaction between the 2 products. My question is "Is this an acceptable prac
Electronics Forum | Tue Oct 04 20:31:16 EDT 2016 | davef
IPC-7721, Section 6.1, Jumper Wires, Jumper Wire Selection #5 states: "Recommended wire is solid, insulated, plated copper wire, 22 to 32 AWG with a heat resistant insulation. Wire with tin-lead plating may be restricted due to environmental laws."
Electronics Forum | Sat Oct 08 11:57:58 EDT 2016 | davef
A friend in the contract coating business said: "... ask why the wire is [teflon] coated in the first place, as only the solder joints should be coated in this situation as the flexing/bending of the wires will cause the coating to crack and flake of
Electronics Forum | Thu Apr 21 17:22:29 EDT 2005 | davef
We prefer epoxy.
Electronics Forum | Thu Apr 21 12:35:15 EDT 2005 | jdumont
Well that doesnt sound very promising. What im going to do is make sure these two boards I just coated (with the RTV already cured) will be used in house only. In the future we will do any conformal coating operations before potting with whatever mat
.gif)
.gif)
winsouce.jpg)