Electronics Forum | Tue Dec 05 13:59:40 EST 2006 | Todd
The "Relay PCB" is # CON I/F 8909-0. Of course it's a real old drawing with many of the P/Ns being obsolete. I'm looking at drawing # SIP-1750. The Relay PCB is shown between the 1st station connectors and the control box. In the meantime, I'll doubl
Electronics Forum | Fri Dec 08 10:24:11 EST 2006 | pjc
The Speedline Technologies- Electrovert AquaStorm 200 is one machine that can do the trick. You'll need the Chemical Isolation option for the RMA flux and you'll need a cleaning chemistry like what Zestron and Kyzen have. Yes, hi-density boards with
Electronics Forum | Sat Dec 23 01:00:38 EST 2006 | mika
Of Course you can. We have a customer specific board that has a stupid connector underneith, and we must manually glue this one onto it's postition before reflow on the secondary side first... And as you know, the customers is alwayw left... The funn
Electronics Forum | Wed Feb 14 12:09:34 EST 2007 | rob_thomas
This was a rather intersting little project to work on due to the fact that I had such a variety of components placed in SMT ( your regular 0402 passives, ,BGA's Qfp's ,TH and SMT connectors ,plus the pesky micro BGA) I ended up with a 5/3 mil electr
Electronics Forum | Tue Feb 20 20:40:03 EST 2007 | vshan
Hi Chris Good day!!! could you please let me know what kind of basket yu r using. Currrently we are using 30 by 40cm stainless steel carrier. Top n bottom design with square type. The area of connectors are open so that the water hits the connetor d
Electronics Forum | Thu Mar 08 09:00:50 EST 2007 | Rob
Thanks for the answers. Hi Dave, I'd love to use some of the durastone we have here, or some Durapol or Delmat (never used Glastic before though), however we need a compliant material for the blade to go into slightly, otherwise they tend to snap or
Electronics Forum | Sun Mar 25 17:02:41 EDT 2007 | johnwnz
Folks, I may be havign a thick day, it is Monday afterall and it has been very sunny over the weekend. We have recently started buildign a fairly high volume of products that is using intrusive reflow on two PTH DIN connectors and havign soem good s
Electronics Forum | Wed Mar 28 08:34:31 EDT 2007 | Mark
Hello, I am trying to find out your opinion about using soldering bench top soldering robot to solder THT connectors (diffrent). What is your experinces and what is limitation for this system. We can't use wave soldering machine due to the complex
Electronics Forum | Mon Apr 02 09:16:08 EDT 2007 | ed_faranda
Was wondering if anyone had any experience with Pin Though Paste with a no-lead process? I realize that some basic requirements will need to be met (i.e. Connector to with stand higher temperature, proper lead coating, ability to image, etc.). But,
Electronics Forum | Thu Apr 05 09:18:14 EDT 2007 | pjc
Please note that pin holes and blow holes are not always defects. The latest IPC 610A Rev D workmanship standard has them as process indicators- depending on Class. I don't have the document handly while writing this. It would be good to look that up