Electronics Forum | Fri Jan 12 11:18:09 EST 2007 | kglidden
J-STD-001 makes RECOMMENDATIONS but they are not REQUIREMENTS. Only REQUIREMENT is to make sure your ESD control is adequate if RH falls below 30%.
Electronics Forum | Tue Feb 13 15:27:09 EST 2007 | davef
Roland On the main Forum page, the ads in the right margin are back to their old piggyselves again. They've bloated themselves upto 2.5 inches wide from their former svelt 1.5 inches wide. Portion control and exercise, portion control and exercis
Electronics Forum | Tue Mar 13 12:54:58 EDT 2007 | hynergy
You required the process control equipments. 1) Paste Height Checker: To measure the solder paste thickness after printing. 2) Temperature Profiler: To measure the reflow oven temperature whether is within the control spec.
Electronics Forum | Tue Apr 03 09:42:05 EDT 2007 | oster
We currently have two 9700 Emulsonator board cleaners, would like to chat with others who are having problems with flooding, controller problems and have done the controller upgrade. Thanks
Electronics Forum | Thu May 31 18:37:22 EDT 2007 | alandra516
I dont know if this helps, but the FDC was made by ECD controls. You might contact them
Electronics Forum | Thu Jun 12 09:12:50 EDT 2008 | soudomphong
F4 machine have power to servo cage, but not the control unit. It takes about 20 to 30 minutes for power to come on in the control unit. It has been like this for couple of weeks now. Any idea, suggestion please welcome to respond. Thanks.
Electronics Forum | Wed Apr 22 15:50:24 EDT 2009 | emilioescatel
Hi: I would like to know their opinion about the critical variables that I need to control in a screenprinter(solder paste aplication on PCBs) process and how I can control them. Thanks.
Electronics Forum | Fri Jul 31 17:17:12 EDT 2009 | isd_jwendell
If the sensor can survive the 200C in the molding machine, then could it not survive Pb-free soldering? Maybe not convection reflow, but it should be able to survive vapor-phase reflow. I would control solder height by controlling the amount of paste
Electronics Forum | Fri Oct 02 12:57:13 EDT 2009 | dnebel
Looks like you'll need to reset the controller. That will require turning the Run/Halt swith to Halt and back to Run. That should put an @ prompt on the screen. There is a list of inputs you continue through to reinitiate, but I have forgotten the
Electronics Forum | Tue Oct 13 08:49:09 EDT 2009 | kudamarani08
try "halt" your EMI and check if the @ appear on screan. If yes, type G or P to re-start the system. If NO, make sure 5VDC is present. V2 controller really a tricky one.