Electronics Forum | Mon Nov 29 13:39:48 EST 2021 | oxygensmd
Is it a running machine or a first startup? For me, it seems to be some configuration error. For example problem with some card (iCos, MC, servo controller). At first check table and WPC connectors are fitted properly than check the status LEDs on y
Electronics Forum | Wed Dec 08 10:45:27 EST 2021 | majdi4
Hello Folks , who has an idea on a means of measuring strain gauge in order to control the mechanical deformation on the pcb / SMC .. your proposals are welcome ! Thank you in advance !
Electronics Forum | Sun Feb 06 22:15:26 EST 2022 | cirsol
No, we were not able to complete the process to rebuild the hdd. If any one has more information please post a solution.
Electronics Forum | Thu Feb 17 09:01:26 EST 2022 | sarason
An NDS9936 is a SO-8 MOSFET since this is a SO-16, its likely to be 2, easier enough to chack by compareing the pin patterns. It is what you would expect on a board which is remote on a car harness, and has a control circuit. sarason
Electronics Forum | Tue Feb 22 07:15:50 EST 2022 | micropak
Just wondering if there's any update on your machine issue ?
Electronics Forum | Tue Apr 19 17:34:34 EDT 2022 | dwl
Be careful of MSL level 4 or higher devices on the first side. if they sit out 3 days, they will need to be baked before second side reflow or you risk component damage.
Electronics Forum | Wed Apr 20 03:34:13 EDT 2022 | sophyluo1985
In the past we have solved problems like this for my clients, You can send me an email and tell me your problem and our engineering team will know how to deal with it.sales07@goldlandsmt.com
Electronics Forum | Fri Jun 03 11:16:21 EDT 2022 | jdengler
Sorry no. Check the pocket on the door for the controller. Usually there is a printout of a proper for that machine. You can them type in the numbers. This would be better than a proper from another machine as it has the calibration of your machi
Electronics Forum | Wed Aug 03 14:09:57 EDT 2022 | emeto
1. Add controls in programming and setup creation for polarity 2. Check polarities in actual setup before you run. They should match the paper.
Electronics Forum | Wed Nov 23 19:08:20 EST 2022 | leeg
You should be able to check the sensor, most had have the red light to indicate that a PCB is being detected. Depending on the version of software it should tell you within the manual control option too