Electronics Forum | Thu Oct 30 09:23:34 EDT 2008 | jwolvans
Hi, Rob. Does the table appear to hang up, then suddenly let go? If so, check the alignment of all four conveyor rail guide blocks, especially if the clamping rails have been recently removed for maintenance. After that, check the piston assembly t
Electronics Forum | Thu Jul 23 09:30:22 EDT 2009 | dekhead
It isn't clear if it was working and stopped, or if this is the first time you've tried to make it work. If this is first try, need to confirm cards and cables on DEK, and what interface is configured on UIC. I have SMEMA cards in stock if needed. P
Electronics Forum | Thu Jul 23 13:09:04 EDT 2009 | dekhead
We're most likely looking at X9 Personality card... You can swap X8 and X9. Can't recall seeing a failure in SCB40 in the 15 yrs I've been doing this. If not the personality then the PCIB (#5) in the PC. Feel free to contact directly (dh1@dekhead.c
Electronics Forum | Wed Oct 07 10:04:07 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech > support he think there is a short some where in > the motor. I changed the motor out and still have > the same problem. The chain is normal, and using > automatic lubricating. I will check more
Electronics Forum | Thu Nov 05 10:02:54 EST 2009 | swag
You can buy a couple of conveyors for loading and unloading machine or a real half aced way is to jump SMEMA cable pins with tweezers to get boards in and out. With that method, you could end up with one on the floor at some point with a smashed, de
Electronics Forum | Wed Nov 11 16:37:01 EST 2009 | isd_jwendell
I used a TWS800 oven, like this one: http://www.smtnet.com/company/index.cfm?fuseaction=view_company&component=mart&item_search_id=70879 for a number of years. It worked OK, but I like the conveyor versions much better, like this one: http://www.te
Electronics Forum | Thu Dec 17 03:55:41 EST 2009 | tod1967
Inspect your dispensed or printed adhesive deposits 100%, make sure your Pnp gives 100% 1st time placement and your cure is adequate. Conveyor or manual brd transfer can also be an issue. usually is in the process. Hopefully your following Loctite
Electronics Forum | Thu Dec 10 15:33:55 EST 2009 | duso02
We use one quite often. Our machine is a Uvitron Conveyor 40 as we are a large coating house and this allows us to process many boards. Dymax also maufactures and sells machines as well. Humiseal and Dymax both manufacture UV coatings. Emerson Cuming
Electronics Forum | Mon Jan 04 21:10:39 EST 2010 | cbart
Having them made by a local supplier is the fastes cheapest and most accurate way to get replacements when the manufacture no longer supports. If its broken and you need it ASAP I have used spider wire (fishing line) to mesh back together. laugh all
Electronics Forum | Wed Jan 20 04:21:11 EST 2010 | josh_brubaker
If it's just a break, you can easily glue it with a 2-part glue from Coolchem.com Look for the Integrator 75 and Activator 310. I was surprised at how well the glue holds up. This is one of those mystery products where the repair becomes stronger th