Electronics Forum | Mon Aug 21 10:08:31 EDT 2017 | vincent1991
hi guys. i looking for to reduce the cycle time as much as possible. but i dont want to increase the the fault or misalignment so i need to know the best delay time for pickup delay & place delay for smd package or part . i need your help & experien
Electronics Forum | Thu Aug 24 07:40:32 EDT 2017 | stephendo
Doing regular maintenance will usually make a bigger difference than reducing delay time.
Electronics Forum | Wed Sep 22 03:46:02 EDT 2021 | zxcvb
Hi all, I bought a PT2399 delay after reading a detailed introduction article about this device, here's the link:https://www.apogeeweb.net/circuitry/pt2399-delay-features-datasheet-application-circuit.html It says that BU9253 is the alternative of PT
Electronics Forum | Wed Aug 23 02:09:48 EDT 2017 | vincent1991
hi dear i must say the machine has optimized but i want to reduce the time . i want but i afraid to reduce delay to make defect part or machine dump it . so i need the best peak & place delay time for all component .
Electronics Forum | swag |
Wed Jun 29 11:17:07 EDT 2011
Electronics Forum | Thu Aug 24 18:28:41 EDT 2017 | tey422
dwl is right. You just have to spend some time to play with all the ones that causing the most delay. I would say the timing for X & Y axis try to set to max speed first (as long as not drops before placing). Then, slowly increase the Z speed until
Electronics Forum | Fri Aug 26 10:44:37 EDT 2022 | gfe
In the Mirae machine we can give an individual delay for each component, in this case the delay in Z is in all of them, the nozzle stays on top of the component for a long time, this happens in any program, could we have accidentally changed some con
Electronics Forum | Wed Apr 26 09:18:19 EDT 2017 | dentata911
Hello Is it possible to make really big placement delay on this maschine? 3-4 seconds? Thank you.
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L
Electronics Forum | Wed Nov 02 11:42:54 EDT 2022 | bobpan
check 'machine' then 'parameters' and make sure 'part check wait delay' is set to 0. Also I would turn off CDON usage in 'ANC' for each head. If they are set to 'YES' change them to 'NO' and see what happens.
