Electronics Forum | Tue May 21 16:48:29 EDT 2019 | Matt
Hey, thanks for your feedback, this was our initial thought however our process engineers don't buy this. Although they are close to the card edge this product only has de-panel length wise which is perpendicular to these capacitors. The PCB its
Electronics Forum | Wed Nov 13 02:28:27 EST 2019 | trino
Hello, I am a Japanese engineer. I am sorry for my unskillful English. Have you ever encountered cracks in chip resistors or IC components due to board mechanical stress? Especially, I'm looking for a case in the PCBs Depaneling process(pizza cutte
Electronics Forum | Fri Dec 20 17:09:52 EST 2019 | slthomas
I agree, that is not a gullwing lead in the normal sense but that doesn't address the failure. The wetting looks fine unless there is a problem under the lead, which is hard to tell since there is an obvious fracture. That appears to be the edge o
Electronics Forum | Wed Jan 22 11:18:26 EST 2020 | emeto
It is all PCB design based for me. Auto router is great as you can pick tabs locations to avoid stress on components close to the PCB edge. For some boards you can hardly justify anything other than manual V-score. So I would say there is no better w
Electronics Forum | Wed Jan 22 11:21:30 EST 2020 | dontfeedphils
To clarify a bit, I'm looking for opinions in regards to automated routing, both tab and scored. If we end up doing a majority of our layouts scored then we'll go with an automated saw for that. That's the question though, has anyone used one of th
Electronics Forum | Fri Feb 21 11:49:25 EST 2020 | SMTA-Tom
Tabs are generally faster to cut through vs a v-scored board. Cutting the V-scored boards with a saw is an option but it is not faster...it just decreases the potential damage that can happen when using a pizza cutter. Preferred method would be to us
Electronics Forum | Mon Feb 01 12:49:26 EST 2021 | proceng1
Perhaps for the future, you could have your board house add copper thieving to the edges. I don't know if that will increase cost though. Most of our arrays come in with copper thieving and we don't ask for it. At least then you'd have copper in
Electronics Forum | Thu Jan 28 20:56:40 EST 2021 | tey422
I am looking for a PDF copy of the old Sayaka SAM-CT23Q programming manual. Seem like 1 of the parameter setting is got accidentally changed to new value; need to reteach the "standby position". If you happen to have a copy of the manual, please shar
Electronics Forum | Fri Dec 24 07:49:13 EST 2021 | bazzah83
I am looking for some help with re-branding our special processes department. This departement consists of activities including PCBA Depanel, selective & wave soldering, PCBA wash processes, potting & coating, Leaded & lead free dipping. Need a nice
Electronics Forum | Fri Jan 07 16:30:53 EST 2022 | tey422
I have a quick question, what's the tallest (highest) SMT part you ever encounter? 1.5 inch or more? I have to set a depanel router's clearance height. It would need to recalibrate again every time if the spindle or camera's height is adjusted. There
Depanelizer Equipment and Tools For Electronic Assembly. PCB Racks and Trays. Wire Crimp Press and Tooling.
115 Pleasant Street
Millis, USA
Phone: 508 376 2500