Electronics Forum | Thu Nov 03 13:52:10 EDT 2011 | dontfeedphils
I'm going to suggest Mirtec. I've worked with many different manufacturers of AOI's (Cyberoptics, Mirtec, Omron, and Yestech) and if I could recommend one AOI for sure it would be the Cyberoptics above all. But when asking between the Yestech and
Electronics Forum | Mon Nov 14 01:46:12 EST 2011 | julien
We already have contact with Zestron and we try several chemicals and process (Immersion, aspersion, vapor degreasing). And we always find something under low standoff component. Concerning the flow pressure and shadowing, we try different position
Electronics Forum | Wed Jan 11 10:22:42 EST 2012 | swag
We had same trouble with one (different mfg.). Sent it back 3 or 4 times for repair. Turned out to be a small burr in the machining on the internal parts that house the air bladder. Same thing happens if you have a burr on a bicycle tire rim. Tou
Electronics Forum | Thu Mar 01 09:09:04 EST 2012 | cbeneat
We bought two of the nozzles from count on tools. The jury is still out. The vacuum thick errors or the lights sticking at this time has dropped, I reduced the air for the vacuum break to a more reasonable level. There is still some work to do on
Electronics Forum | Mon Apr 09 06:39:50 EDT 2012 | eniac
Last 4 years I work with printer by SJ Inno Tech, model HH-520. This model have all what you want - fully automatic alignment, 2D inspection, many different pins for PCB fixing - and no any problems during this 4 years. P.S. Sorry for my English, I'
Electronics Forum | Wed Apr 04 07:33:31 EDT 2012 | christian01976
Hello! For "gang-pick" you need to have nearly the same Pick High. And for simultanious scan over the camera the Z Value of the parts have to be nearly the same too. The allowed differences are somewhere in the Machine Info or Machine Config. Try so
Electronics Forum | Fri May 04 11:47:56 EDT 2012 | pctech
Hi, It's not advised to hard-down the re-flow oven.There are two reasons for that ; extreme thermall difference in temp. will cause chain and drive shafts to warp and T/C's to crack.Let your "cooldown" profile do this safely within 45 mins. to an hou
Electronics Forum | Wed Jun 06 10:28:39 EDT 2012 | kahrpr
You need to get your local rep to demo the grid loc. That is what it is for double sided boards. when the table comes up the pins adjust to the different height components. I also thought I saw a similar product on one of the advertising Panes on thi
Electronics Forum | Wed Jun 13 01:01:10 EDT 2012 | isd_jwendell
I clean all fids with a fiberglass brush pencil so that I know there will be no rejects (it doesn't take too long). The problem is the machine lighting. My Essemtec machine uses a light ring (red LEDs) around the cam. Here's one of many documents th
Electronics Forum | Mon Jul 02 16:35:33 EDT 2012 | stentech
There are a few different ways depending on the vendor. If they have the board and overlay it once it is cut. Make adjustments if necessary. If it is a double sided board do you see any movement after the first reflow? This should also be taken into
.png)