Electronics Forum | Sun Nov 24 12:44:10 EST 2019 | bane016
I have problem with feeder cart.I have no voltage on any of the 17 feeder connectors, and when i insert the cart in the machine i get the message that the cart is not connected. I have a voltage to one separate connector normally.
Electronics Forum | Mon Dec 02 02:29:16 EST 2019 | bane016
Problem solved. Burned electronic on cart.
Electronics Forum | Mon Nov 25 20:52:47 EST 2019 | cbeneat
Are the arms pulling the cart all the way in? Possible part blocking the limit switch. does the cord have power? If I remember correctly, we once had to adjust the mechanical stops on one of ours so it would make the switch.
Electronics Forum | Sat Oct 20 00:34:57 EDT 2001 | kenbliss
Hi mike The solution is simple but two fold, first your process needs to be changed a bit, you need additional feeders to pre-stage the new P/N run and prestage the extra feeders for reload as certain higher volume components exhaust. The idea is t
Electronics Forum | Tue Oct 09 16:25:26 EDT 2001 | meowen
Unfortunately 95% of our runs require both sides of our Universal HSP's. We also have carts that hold one carriage worth of feeders on each side. Parts that carry over from one product to the next are flagged and relocated in the machine per the ne
Electronics Forum | Tue Oct 09 14:59:52 EDT 2001 | slthomas
That's what we do with our MSHII's...setup one carriage offline while the other one runs. We also have setup carts to load the feeders ahead of time and haul them out to the lines. Of course, when we exceed the carriage capacity of 75 slots for an
Electronics Forum | Fri Nov 09 14:42:08 EST 2001 | vickt
Great advice!........Single tier feeder set-up carts are also available through Universal instruments directly for this exact purpose. Most people who really care about this changeover time have "pit-crews" that work in the component storage areas, o
Electronics Forum | Wed Oct 20 11:19:36 EDT 2004 | jax
The HSC, "Lightning Head", is offered on two platforms, Genesis and Advantis. The decision will depend on your throughput needs and price requirements. In comparison to the HSP, I would recomend the HSC. With the ability to use docking feeder carts,
Electronics Forum | Thu Jun 18 15:04:32 EDT 2015 | empac
We have Juki 2000 series feeder carts. Let us know if you have any interest. Thanks.
